Isenberg 1961280BN Deck Diverter Trim With Hand Shower Instruction Manual
- June 15, 2024
- Isenberg
Table of Contents
Made For Responsible Luxury
Installation Manual For 196.1280
Deck Diverter Trim With Hand Shower
1961280BN Deck Diverter Trim With Hand Shower
- Deck Diverter Valve Sold Separately
NOTICE TO HOMEOWNER
- We recommend that this product is installed by a qualified professional plumber.
- Please check this product immediately to ensure that it has not been damaged and is complete. Before installation, please make sure this product is the correct model and you have all the parts required for installation and use.
- Please flush the water system to ensure that no metal swarf, solder, and other impurities can enter the product.
- Turn off water supply before commencing work.
- Please read these instructions carefully and retain for future reference.
BEFORE YOU BEGIN
- You must observe all local plumbing laws and codes.
- Do not install this valve if it does not meet local plumbing codes.
- Shut off the main water supply.
OPERATING SPECIFICATIONS
WATER TEMPERATURE
This product is to be used with water at a temperature range of 40̊F – 120̊F
ONLY!
WATER PRESSURE
This product is to be used with a water pressure range of 15 PSI to 80 PSI
ONLY
If water pressure is greater than 80 PSI install a pressure reducing valve
(PRV)
This valve meets or exceeds ANSI A112.18.1 and ASSE 1016
INSTALLING THE HAND HELD & HOSE
Insert nut and washers and tighten to secure Hand Shower Holder.
Insert hose through the hand shower holder.
Attach second hose and hand held.
Attach weight (optional)
INSTALLING THE DECK DIVERTER AND TRIM
Assemble threaded connector as seen below and tighten hex nut. DKM.2420 valve sold seperately.
insert extender and tighten screw. The deck diverter is now ready to install onto the deck.
Insert assembled deck diverter through deck hole. Tighten hand shower hose onto deck diverter valve
Twist and insert handle base onto assembled deck diverter.
Insert handle and tighten hex screw to secure handle onto deck diverter.
Completely Installed handle set is seen here.
HOSE INSTALLATION
Attach & tighten hoses as seen above.
CARTRIDGE REPLACEMENT
Loosen and remove hex nut to and retaining nut to remove cartridge.