XG-509 Platform A Bronco XG User Manual

June 15, 2024
XG

XG-509 Platform A Bronco XG User

Specifications

  • Product Name: Platform A XG-509
  • Fits : Bronco 2021- Current
  • Maximum Cargo Capacity: 150lb

PARTS LIST

  • 1- Platform A Center Tray
  • 1- Driver’s Side Mount (DS)
  • 1- Passenger Side Mount (PS)

FASTENER LIST

  • 4 — 3/8 16 x 1”
  • 4 — 3/8 16 Nylok Nuts
  • 8 — 3/8 Washers
  • 8 — Rubber Washers |
  • 1 — 7/32” Allen Wrench

SCAN FOR INSTRUCTIONAL VIDEO

Scan the QR code with your smartphone and it will take you to the link below:
https://qrgo.page.link/yYQYH

INSTALLATION TIME & SKILL LEVEL

TOOLS NEEDED

  • Torx Wrench for
  • Roof Side Mounting Bolts.(Varies by Model)
  • 15-20 minutes, Skill Level 01

WARNING!

  • Platform A is engineered to support up to 150lb of evenly distributed cargo. Operator responsible for securing all fasteners and cargo prior to operating vehicle. Do not stack cargo to height that obstructs rear view mirror.
  • Do not carry flammable liquids or solids in Platform A.
  • Do not use Platform A as a bed of any sort.
  • XG Cargo warrants all products for workmanship only and cannot assume responsibility for products abuse or misuse by the end user.
  1. STEP 01
    Remove all components from box and be sure all components including fasteners are intact.

  2. STEP 02
    Remove two (2) hard top mounting bolts closest to back seat on each side of vehicle. Do not remove smaller bolt. Loosely Install side accessory plates as shown with rubber washer under plate at all for bolts. Side mounts are marked DS for driver’s side and PS for passenger side. Do not tighten these bolts until last. Leave loose!

  3. STEP 03
    If installing with one person, install box or support in center of cargo area to elevate center tray to correct height

  4. STEP 04
    Install tray to side mounts using 4 3/8 16 bolts, washers and lock nuts on each side.There are two heights to choose.
    As you tighten bolts, be sure the mounts are aligned with tray. Tighten securely.

  5. STEP 05
    Tighten side mounting plate bolts last. Be sure tray is centered in vehicle. DO NOT USE A LEVEL TO CHECK TRAY LEVEL. Jeeps are preloaded higher on driver’s side. Tray should align with top
    of back seats.

Technical Support No. 1-833-575-8885

www.xgcargo.com

  • Platform A XG-509
  • USER MANUAL
  • Fits Bronco 2021- Current

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals