NapFox Ergonomic Office Chair Instruction Manual

apFox Ergonomic Office Chair Instruction Manual

WARNING

All products come with 12 months warranty. If the product is damage or you need any new part replacement in the future, just contact our after-sales team firstly via the e-mail
( service@napfoxstore.com) to get part replacements . Please do not return the product directly, our team will do the best to offer you satisfactory solutions. Your satisfaction and comfortable experience are our highest pursuits.

1. The product can only be used by one person at a time.
2. Use the product after all screws are securely tightened.
3.  Save the Hex Wrench, and check that all screws aretightened every 3 months or as needed.
4.  Do not use the chair as a stepladder.
5.  Dispose of packing material properly. Do not use the plasti cover as a head covering. It may cause suffocation.
   

Parts

Installation Manual

Step 1.

Attach the 5-star base and base legs with screws
M6 x 15mm, using the Allen wrench.

NOTE:

If the legs cannot be fully inserted into the base, please contact us directly for new legs. X service@napfoxstore.com

Installation Manual

Step 2.

Insert Casters into bottom of Base.
Turn Base right side up on the floor and insert Gas Lift into center hole on Base.

NOTE:

If the wheel is stuck and cannot slide smoothly, please feel free to contact us for new wheels.
X service@napfoxstore.com

Installation Manual

Step 3.

Attach the Armrests to the Seat with Screws M6 x 30mm, using the Wrench.

Installation Manual

Step 4.

Attach Mechanism onto Seat (with front of
Mechanism facing front of Seat) by using Screws M8x20mm. Tighten screws.

Step 5.

Attach the Backrest to the Seat by using Screws  5/16x20mm

.* Note : Do not tighten all the screws to100%, make sure it has space to adjust in the next step. It needs to be adjusted per 3 months.

Installation Manual

Step 6.

Position the assembled chair upright with the seatfacing down. Insert the Gas Lift into the center holeof the Seat and press down until fully engaged anrest it on the Base.
Attach the Headrest to the Backrest by using th screw.

1.To Adjust The Seat Height:

Find the handle under the right side of the seat.Rotate the handle forward, you can adjust the seat height up and down* If the seat height can’t be adjusted normally, please contact our after-sales team for a new gas lift cylinder (service@napfoxstore.com).

2.To Adjust The Tilt Function:

Free: Pull the handle out, the chair backrest can start tilting. Lock: Push the handle in, the chair backrest can be locked in a position you desired. The chair back can be locked at 3 different angles.

3.To Adjust The Back Tilt Tension:

Turn the knob as shown in the figure to adjust the tightness of lean, the back of the chair can be easier to recline. You can see two signs (+, -) that shows 2 different adjustments. 4.To Adjust The Lumbar Support Find the knob on the backrest, adjust the lumbar support up and down, front and back.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>