POCOCO Galaxy Star Projector User Manual
- June 15, 2024
- pococo
Table of Contents
POCOCO Galaxy Star Projector
Specifications
- Projection angles: may cause blurry edges 80% image area in focus is acceptable
- Rotation speed: optimized for most users
- Power adapter output: 5V voltage
Product Usage Instructions
Improving Blurriness of Projected Images:
To improve the blurriness of projected images, follow these steps:
- Check if the projection disc is properly installed in the slot.
- Adjust the focus to ensure proper clarity.
- Remove the lens protection film if present.
- If the issues persist, try installing the projection disc upside-down or use a different disc.
- If the issues are still not resolved, please contact customer service for assistance.
Rotation Speed and Comfort:
The rotation speed of the product has been optimized to accommodate the preferences and experience of most users. The rotation speed has been carefully tested to provide the best experience possible.
Retrieving a Fell Projection Disc:
If a projection disc falls into the projector, follow these
steps to retrieve it:
- Take out the disc tray.
- Tilt the projector so that the slot opening is pointing downwards.
- Shake the projector gently until the disc falls out.
Troubleshooting Rotation Issues
Why the projected images are partially blurry sometimes?
The edge of the images may occur to be blurry due to projection angles. It is acceptable that 80%of the image area is in focus.
The entire projection image is blurry during use. How can I improve this?
1. Check whether the projection disc is properly installed in the slot. 2. Check if the focus is properly adjusted. 3. Check whether the lens protection film has been removed. 4. Try to install the projection disc upside-down or use a different disc. If the issues are still not resolved,please contact customer service.
Why the rotation is slow? Is it due to something I did during the installation?
Each person has their own preference as to the rotation speed. We have conducted many tests to find the rotation speed that accommodates the comfort and experience of most users. I hope to give you the best experience as well.
My projection disc fell into the projector. How can I get it out?
Take out the disc tray, and tilt the projector so that the slot opening is pointing downwards. Shake the projector until the disc falls out of the projector
Sometimes the rotation lags and jams/makes weird noises. What is the cause of this
1. The battery is low. 2. Check whether the tray is inserted fully in the projector. You can check this by running your finger through the tray surface to see if the tray stays flush with the projector. 3. Check whether the projection disc is aligned correctly in the slot.
The focusing wheel is too tight to rotate but the image is still not in focus. What should I do?
1. If the lens is in its upper-most position, rotate the wheel clockwise to loosen the wheel. 2. If the lens is in its lower-most position, rotate the wheel counterclockwise to loosen the wheel.
What is the right charger?
A power adapter can output 5V voltage.
If rotation lags, jams, or makes weird noises, try these solutions:
- Check if the battery is low and replace if necessary.
- Ensure that the tray is fully inserted into the projector by running your fingers along the tray surface to check if it stays flush with the projector.
- Verify that the projection disc is aligned correctly in the slot.
Focusing Wheel Adjustment:
If the focusing wheel is too tight to rotate but the image is still not in focus, follow these steps:
- If the lens is in its upper-most position, rotate the wheel clockwise to loosen it.
- If the lens is in its lower-most position, rotate the wheel counterclockwise to loosen it.
Charger Information:
The right charger for the product is a power adapter that can output a 5V voltage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>