MATTEL HXV82-23A5T 24S RC R0000-MA70 21A Battery Flyer G3 Instruction Manual

: June 15, 2024
: Mattel

Table of Contents

MATTEL HXV82-23A5T 24S RC R0000-MA70 21A Battery Flyer G3
CONTENTS
FEATURES
SET UP
PAIRING THE REMOTE CONTROLLER AND VEHICLE
HOW TO DRIVE
CONTROLS
CONTACT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MATTEL HXV82-23A5T 24S RC R0000-MA70 21A Battery Flyer G3

Keep these instructions for future reference as they contain important information.
IMPORTANT: Please read all instructions before operating your vehicle.

FEATURES

A: HEADLIGHTS
B: TAILLIGHTS
C: POWER SWITCH
D: CHARGE CORD COVER
E: CHARGE CORD
F: LED INDICATOR
G: POWER SWITCH
H: ALIGNMENT BUTTONS
I: LED INDICATOR
J: DRIVING CONTROLS
K: BATTERY BOX

SET UP

REMOTE CONTROLLER BATTERY INSTALLATION

Unscrew the battery cover with a Phillips head screwdriver (not included).
Install 2 AA (LR6) 1.5V alkaline batteries (not included) with polarity (+/-) as shown inside the battery compartment. For longer life, use alkaline batteries.
Replace the battery cover and tighten the screw.
Replace batteries in the remote controller if the LED on the remote controller does not go on during play or if the vehicle does not respond well after a recharge.

CHARGING THE VEHICLE

The vehicle is powered by a permanently installed Lithium-ion (Li-ion) battery, and it must be fully charged before first use.

Slide the power switch to OFF (0/ ).
Remove the charge cord cover with a Phillips head screwdriver (not included).
Connect the charge cord to a 5V/2A USB power adapter (not included).
Charging will begin when the cord is connected. A red LED on the vehicle will be on as the vehicle is charging.
The LED will turn green but remain on for a while when the vehicle is fully charged. Unplug the charge cord when charging is complete. A full charge will usually take approximately 150 minutes. Charging time may vary.
Reattach the charge cord cover.
Consider recharging the vehicle if the vehicle begins to run slowly or does not respond. If the vehicle’s headlights and taillights suddenly flash for approximately 10 seconds, this means the vehicle’s battery is empty. The vehicle will shut off immediately and must be recharged.

NOTE: The power switch must be in the OFF (0/ ) position when charging the vehicle.

TIP: The battery will be hot after play. Wait at least 10 to 15 minutes until the battery cools down before recharging the vehicle.

PAIRING THE REMOTE CONTROLLER AND VEHICLE

Slide the power switch to the ON (I) position on the vehicle.
Switch the remote controller on after switching on the vehicle.
Pairing is complete when the vehicle’s headlights and the remote controller’s LED stop flashing and remain on.

NOTE: If the LED indicator does not stop flashing in approximately 10 seconds, switch off the vehicle, turn it back on, and then switch the remote controller off and on to try pairing again.

TIP: The vehicle will go into sleep mode if left idle for approximately 15 minutes to preserve battery life. To resume normal play, slide the vehicle’s power switch to OFF then ON again, and then push the remote controller’s driving control joystick forward/backward to pair the vehicle and remote controller.

STEERING ALIGNMENT

Check the vehicle’s steering alignment before playing by driving it forward to see if it is driving straight.
If the vehicle automatically steers toward the right/left, press the alignment button in the opposite direction a few times until it runs in a straight line.

HOW TO DRIVE

CHECKLIST

Is the vehicle fully charged?
Is the remote controller equipped with fresh batteries?
Is the remote controller paired with the vehicle?
Has the vehicle’s steering been aligned?

CONTROLS

NOTE: The operating range of the remote controller is up to 30 m (100 ft).

BATTERY REMOVAL

NOTE TO ADULTS: Please follow these steps to remove the Li-ion rechargeable battery pack before disposing of the product.

Switch off the vehicle, and then unscrew and remove the vehicle cover with a Phillips head screwdriver (not included).
Unscrew the battery holder and the circuit board from the vehicle.
Unplug the Li-ion battery pack from the circuit board and dispose of it in accordance with your local battery collection and recycling regulations.

HVIN: HXV82R ( ), HXV82T ( )

Operating Frequency: xxxxMHz – xxxxMHZ
Maximum radio frequency power transmitted:
xxxdBm / xxxmW (for EU compliance
xxxdBm / xxxmW: (for EU compliance

CONTACT

Tesla, Inc. and all related marks and emblems are intellectual property rights of Tesla, Inc. used under license to Mattel, Inc.
©2023 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted.
Inc., Mississauga, Ontario L5R 3W2. You may call us free at/ Composez sans frais le 1-800-524-8697.
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland. Mattel U.K.
http://www.service.mattel.com/es. Mattel Australia Pty. Ltd., 658 Church St., Richmond, Victoria, 3121.Consumer Advisory Service – 1300 135 312. Hong Kong: Kids Kingdom
Limited, Room 1908-9, Gala Place, 56 Dundas Street, Mongkok, Kowloon, Hong Kong. Customer Care line: (852)2782-0766. Taiwan: Chickabiddy Company Limited, 5/F, No. 186,
Section 4, Nanjing East Road, Taipei 10595, Taiwan. Customer Care line: (02)2578-1188. Mainland China: Mattel Barbie (Shanghai) Trading Co., Ltd. Units 4701-4711, 47F, 2 Grand
Gateway, 3 Hong Qiao Road, Shanghai, 200030, P.R.C. Customer Care line: 400-819-8658. Diimport & Diedarkan Oleh: Mattel Continental Asia Sdn Bhd. Level 19, Tower 3, Avenue
7, No. 8 Jalan Kerinchi, Bangsar South, 59200 Kuala Lumpur, Malaysia. Mattel South Africa (PTY) LTD, Office 102 I3, 30 Melrose Boulevard, Johannesburg 2196. Mattel, Inc. 636
Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Services 1-800-524-8697
Tel.: 0800-54744. E-mail Latinoamérica: servicio.clientes@mattel.com.
Limited, The Porter Building, 1 Brunel Way, Slough SL1 1FQ, UK.