Ektor 11546 EV Ledfire Core Surface Mounted Emergency Light Instruction Manual

June 15, 2024
ektor

Ektor 11546 EV Ledfire Core Surface Mounted Emergency Light

EV-LEDFIRE-SM-CORE-IP65(-B)

SPECIFICATIONS

  • Voltage: 220-240 V~
  • Frequency:  50 Hz
  • Ambient temp.:  50°c
  • Class:  2
  • Classification:  CO: D50
  • Rated duration: 90 min
  • IP rating:  IP65
  • Mounting type:  Surface
  • Wiring:  Terminal Block

Ledfire Core Surface Mount Emergency Luminaire

  • Battery spec: 3.2V 21 OOmAh
  • Battery type: LiFeP04
  • Average Power Consumption : 0.4 W
  • Max. Power Consumption : 2 W

**SPACING TABLE

**

(DISTANCE BETWEEN FITTINGS)

*Care should be taken when spacing lumlnaires at the distance indicated by shaded regions to ensure that conformance to AS/NZS 2293.1 :2018 Clause 4.3 is maintained (i.e. maximum SOOm2 per emergency lumlnaire).

ORDER INFORMATION

Order code SKU Description
EV-LEDFIRE-SM-CORE-IP65 11546 Ledfire Core Surface Mount IP65 – D50
EV-LEDFIRE-SM-CORE-IP65-B 11547 Ledfire Core Surface Mount IP65 – Black –

D50
EV-LEDFIRE-SM-ADV-IP65| 11555| Ledfire Advanced Surface Mount IP65 · D63
EV-LEDFIRE-SM-ADV-IP65-DA| 11548| Ledfire Advanced Surface Mount IP65 DALI· D63
EV-LEDFIRE-SM·ADV-IP65-B·DA| 11549| Ledfire Advanced Surface Mount IP65 – Black – DALI – D63
EV-LEDFIRE-SM-ADV-IP65-LK| 11550| Lynk Advanced Ledfire Surface Mount IP65 – D63 – with Wireless
EV-LEDFIRE-SM·ADV-IP65-B-LK| 11551| Lynk Advanced Ledfire Surface Mount IP65 – Black – D63 – with Wireless

SAFETY WARNINGS

  1. This product must only be installed by a suitably qualified person.
  2. Before commencing installation turn off and isolate the electrical supply.
  3. Supply voltages within the product. Isolate supply voltages before opening or servicing.
  4. There are no user-serviceable parts.Do not attempt to service other parts as this will void the warranty
  5. As the installer, it is your responsibility to ensure you comply to all relevant building and safety codes. Refer to application standards for the relevant rules.
  6. When the ac power is cut or when pressing the test button, the luminaire will operate in emergency mode.
  7. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or  a similar qualified person.
  8. Do not insulation test over 500vdc.
  9. The rechargeable device will operate normally after the removal of short circuit fault.
  10. The luminaire is connected to an unswitched active during normal operating conditions. When disconnected from the mains supply, the luminaire is powered by a LiFeP04 battery operated inverter. Due to this, care should be taken when replacing the battery.

The leaflet is subject to change without notice. See separate leaflet for Warranty

LAST UPDATED: 24.06.22 V2.1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals