HAVIT HV3649T-BLK-12V Essil Wall Light Instruction Manual
- June 4, 2024
- havit
Table of Contents
Essil Wall Light Installation Instructions
Product Specifications
| Model No. | HV3649T-BLK-1 2V | HV3649T-WHT-1 2V | ||
|---|---|---|---|---|
| Name | Essil | |||
| Material | Aluminium | |||
| Colour | Black | White | ||
| IP Rating | IP54 | |||
| Input Voltage | 12v DC | |||
| Lamp Base | Built in LED | |||
| Lamp Wattage | 2x 6w | |||
| Colour Temp | TRI Colour – 3000k, 4000k, 5500k | |||
| Lumens | 2x 3501m, 2x 360lm, 2x 3601m | |||
| CRI | > 80 | |||
| Wiring | Parallel | |||
| Dimmable | No | |||
| Warranty | 2 Years Replacement* |
Dimensions
Mounting Base Diagram
Important Safety Issues:
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Do not exceed maximum wattage restrictions for globes: 240V GU10 = 35w / 12V MR16 = 20w
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
- Aluminium and 304SS fittings must not be installed within 2km of any saltwater environments.
- When installing copper fittings, gloves must be worn to avoid any oils transferring to fitting.
- All 316 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on fitting. (Warranty does not cover Tea Staining)
- All o-rings and seals must be in place correctly to maintain warranty.
- These instructions may be updated at any time due to product improvements, Please visit the website for most current installation instructions.
Steps for Installation:
- Make sure that the electrical circuit is free of voltage (master switch off )
- Loosen allen screws on side of fitting
- Remove base plate from fitting and attach base plate in the desired location
- Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
- Connect the cable – If more than one fitting is installed, wiring must be done in parallel.
- Fitting is preset to 3000k, to change the slide switch to desired color temperature
- Reattach fitting to baseplate making sure screws are tight to avoid water penetration.
- Apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Must be installed by a licensed electrician
Contact Details:
143 Beauchamp Road
Matraville NSW 2036
Australia| Tel: 02 9381 8300
Fax: 02 9666 8881
Email:
sales@havit.com.au
Web: www.havit.com.au
---|---
**Warranty Terms & Conditions***
https://havit.com.au/pages/warranty-terms-and-conditions
Additional Information
|
https://havit.com.au/collections/all/products/hv3649t-blk-essil-black-up-
down-led-wall-light| https://havit.com.au/collections/all/products/hv3649t-
wht-essil-white-up-down-led-wall-light
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>