EMANER 7042 Dimmable Flood Light Instruction Manual
- June 15, 2024
- EMANER
Table of Contents
EMANER 7042 Dimmable Flood Light Instruction Manual
WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO TURN POWER OFF AT CIRCUIT BREAKER OR FUSE.
NOTES:
- Some codes require installation by a qualified electrician.
- To avoid hazard, read instruction carefully before installing and save this instruction.
- Customer support: support@emaner.com
Hardware Package (included)
- Mounting Screw 1#
#5/32 X 3/4 in X3
- Mounting Bracket Screw
#5/32 X 1/2 in X2
- Fixture Mounting Screw
2 #5/32 X 3/4 in X1
-
Decorative cover
-
Mounting Strap X1 Wire
-
Connector X3
-
Mounting Screw 2#
-
Expansion Screw
-
Gasket x1
Important to Know
- The light control requires 100-130-volts AC.
- Some codes require installation by a qualified electrician.
- This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.
- Maximum Wattage: 28W
- Working Temperature Range: -22ºF ~ 113ºF
Features
- Energy saving LED security light fixture.
- When the sensor triggered the passing of person, car or animal, the light will turn on, and then turn off after 1minute.
- Sensing distance: 4-8meters.
- IP65 waterproof rating of this product.
Installation Notes
Wall Mounted
**Eave Mounted
**
Installation Step
-
Turn off power to the work area at the circuit breaker main or fuse box.
Note: do not rely on the wall switch turns off the power. -
The Yellow&Green- Earth Wire (Ground Wire) is fixed to the aluminum mounting strap. Fix the aluminum mounting strap to the outlet box.
-
Fix the gasket to the outlet box. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
- Black – Live Wire (Hot Wire)
- White – Neutral Wire (Naughty Wire)
- Green to Ground wire
Carefully tuck the wires back into the outlet box. Fix the Back Plate to the mounting strap
-
Fix the lamp body to the Back Plate, use the fixture mounting screw(longest), put on the white decorative cover after fix the lamp body. Turn on power to test the light in TEST mode.
CAUTION: Be sure to caulk completely where the back plate meets the wall surface to prevent water from seeping into the outlet box.
Product description
- Model No.: 7042-28W-XX(XX=WH / BK)
- Maximum Wattage: 28W
- Luminous Flux: 1400lm*2-Head
- Surface Color: White/ Black
- Lens finish: Frosted (Anti-glare)
- CCT: 3000K / 4000K / 5000K
- CRI (Ra): ≥80
- Input Voltage: 100~130V AC, 60Hz
- Power Consumption: 14W*2-Head
- Lifespan: ≥50000 Hours
- Motion Sensor Time Delay: 1 minute