Russell Hobbs 26480-56 Light and Easy Brights Steam Iron User Manual
- June 15, 2024
- Russell Hobbs
Table of Contents
- 26480-56 Light and Easy Brights Steam Iron
- IMPORTANT SAFEGUARDS
- PARTS
- BEFORE USING FOR THE FIRST TIME
- PREPARATION
- FILLING
- SWITCH ON
- TEMPERATURE SETTING GUIDE
- STEAM IRONING
- SPRAY
- SHOT OF STEAM
- DRY IRONING
- VERTICAL STEAMING
- AFTER USE
- CLEANING
- ANTI-SCALE
- RECYCLING
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
26480-56
www.russellhobbs.com
26480-56 Light and Easy Brights Steam Iron
Read the instructions, keep them safe, pass them on if you pass the iron on.
IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been supervised/instructed and understand the
hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be done by children unless they are older than 8
and supervised. Use and store the appliance out of reach of children under 8
years.
Use the iron, or set it on its heel, on a stable, level, heat-resistant
surface, preferably an ironing board.
Don’t leave the iron unattended while plugged in, or while it’s standing on
the ironing board.
Unplug the iron before filling, before cleaning, and after use.
Don’t operate the appliance if it’s dropped or damaged, or if it malfunctions
or leaks.
If the cable is damaged, return the iron, to avoid hazard.
The surfaces of the appliance will get hot during use.
Do not use this appliance near bathtubs, showers, basins or other vessels
containing water.
- Don’t iron clothing while it’s being worn – you’ll injure the wearer.
- Don’t use the appliance for any purpose other than those described in these instructions.
- Don’t scratch the soleplate – avoid buttons, zips, etc.
- The appliance has a protective thermal fuse, which will blow if it overheats. If this happens, the appliance will stop working, and must be returned for repair.
HOUSEHOLD USE ONLY
PARTS
1. Light
2. Temperature control
3. Water inlet
4. Cover| 5. Spray nozzle
6. Soleplate
7. Reservoir
8. Heel
---|---
BEFORE USING FOR THE FIRST TIME
- Remove labels, stickers and packaging from the iron and soleplate.
- Don’t worry if the iron smokes a bit at first, it’ll stop as the element cures.
- Iron an old piece of cotton fabric, to clean the soleplate.
PREPARATION
- Check for textile care symbols ( ).
- Iron fabrics needing low temperatures first, then those that need medium temperatures , and finish with those needing high temperatures .
FILLING
You may use the iron with tap-water, but if you live in a hard water area, you
should use distilled water (not chemically descaled or softened water).
If you buy distilled water, check that it’s suitable for use in irons.
- Unplug the iron.
- Set the temperature control to •. Set the steam control to .
- Open the cover.
- Pour slowly, to let the air in the reservoir escape, otherwise you’ll cause an air lock and the water will overflow.
- Don’t fill past max, or water will escape in use.
- Wipe up any spillage.
SWITCH ON
- Set the temperature control to •. Set the steam control to .
- Sit the iron on its heel.
- Put the plug into the power socket (switch the socket on, if it’s switchable).
- Turn the temperature control to bring the setting you want next to the mark. The light will come on.
- When the iron reaches the temperature you set, the light will go off. It’ll then cycle on and off as the thermostat operates to maintain the temperature.
TEMPERATURE SETTING GUIDE
Label marking | Dot setting |
---|---|
cool – nylon, acrylics, polyester | • |
warm – wool, polyester mixtures | •• |
hot – cotton, linen | •••/max |
do not iron | – |
If the instructions on the fabric label differ from this guide, follow the instructions on the label.
STEAM IRONING
- If you intend to use steam, the temperature setting must be or higher.
- Set the steam control to the setting you want ( = no steam, high).
- Wait till the light goes off, then start ironing.
SPRAY
Water spotting affects some fabrics. Test this out on a hidden part of the fabric.
- Lift the iron off the fabric.
- Aim the spray nozzle at the fabric.
- Press the button – you may have to press it 2 or 3 times to pump water through the system.
SHOT OF STEAM
If you intend to use steam the temperature control must be at or higher.
- Lift the iron off the fabric.
- Press the button.
- Leave 4 seconds between shots, to let the temperature build up.
DRY IRONING
If you’re going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid spontaneous bursts of steam.
- Set the steam control to .
- Wait till the light goes off, then start ironing.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
- Check that there’s adequate ventilation behind the fabric, otherwise moisture may build up, causing mildew.
- Check that there’s nothing behind the fabric that may be damaged by the steam.
- Check that pockets, turn-ups, and cuffs are empty.
- Check that there’s water in the reservoir.
1. Set the temperature control to max. Set the steam control to .
2. Hold the iron close to (but not touching) the fabric.
3. Press the button (you’re using the “shot of steam” function vertically).
4. Leave 4 seconds between shots, to let the temperature build up.
AFTER USE
- Set the temperature control to •. Set the steam control to .
- Unplug the iron.
- Open the cover.
- Hold it over a sink, turn it upside down, and drain the water from the reservoir, via the water inlet.
- Close the cover.
- Sit the iron on its heel.
- Leave it to cool down completely.
- When it’s cold, wipe off any moisture, and wind the cable round the heel.
- Store the iron on its heel, to avoid corrosion and damage to the soleplate.
CLEANING
- Unplug the iron, and sit it on its heel to cool.
- Clean the outside surfaces of the appliance with a damp cloth.
- Remove spots from the soleplate with a little vinegar.
ANTI-SCALE
- The anti-scale agent incorporated in the iron helps prevent the build-up of scale.
- Don’t use a descaling solution, or you’ll destroy the anti-scale agent.
RECYCLING
To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/collection point.
26480-56 220-240V~50/60Hz 2150-2600Watts
26480-56 220-240В~50/60Гц 2150-2600 Вт
T22-9002389
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>