always BT2301 Wireless Mini Speaker User Manual
- June 15, 2024
- always
Table of Contents
Wireless Mini Speaker
User Manual
Included in the box:
– Wireless speaker
– USB-cable for charging
– User manual
Pairing instructions:
- Switch the button at the bottom of the speaker base to the “On” position. The speaker will give a prompt sound and the blue led will begin to flash, indicating the speaker is ready for pairing.
- From your media device (smartphone, tablet, etc..), browse the list of wireless devices available for pairing, select wireless speaker “Go Army”.
- Your wireless speaker is paired and ready for use.
Charging the battery:
- Plug the provided USB cable into the speaker’s micro USB slot on one end and an active computer USB port or a USB AC adapter that is plugged into an active wall outlet on the other end.
- The LED will emit a solid red light indicating the speaker is actively recharging.
- When the device is fully charged, the red LED light will automatically turn off.
Specifications:
- Speaker: D50mm (200HZ-20KHZ)
- Power output: 3W 4Q
- SNR:=90+3DB
- Wireless effective range: up to 10 meters
- Charging voltage: DC5V
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .The device has been evaluated to meet general RF
exposure requirement.
The device can be used in portable exposure condition without restriction. FCC
ID: 2BC8E-BT2301
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>