FLASH FURNITURE 802-BRN-GG Classic Executive Swivel Office Chair Instruction Manual
- June 14, 2024
- Flash Furniture
Table of Contents
802-BRN-GG Classic Executive Swivel Office Chair
Instruction Manual
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you
begin. Carefully remove all of the components from the packaging and set aside
for assembly. Assemble on a soft surface to prevent scratching during
assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in
personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to
product or components may result. Please align the hole of the triangle
bracket with the nut on the side of the back seat cushion. Once aligned begin
install the screws the screws should be able to be turned into the nuts by
hand. When the screw is secured tighten the rest of the screw with a tool.
Warning:
CHOKING HAZARD – Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must
install Tipping Restraint Hardware (where included) to help prevent the unit
from tipping and causing accidental injury, instability, death or damage.
The tipping restraint is intended only as a safety measure, it is not a
substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to
the wall. Anti-Tip Safety Wall Straps suitable for the unit weight and wall
materials (if not included) should be purchased and installed.
Online Assembly Instructions:
http://ftp.flashfurniture.com/AssemblyInstructions/802-BRN-GG.pdf
Insert and loosely tighten all
screws. When assembly is completed, fully tighten ail screws before using.
This chair is only intended for sitting. Any other use will void the
warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>