mingqian IC003S Solar Automatic Watering System User Manual
- June 14, 2024
- mingqian
Table of Contents
Solar Automatic Watering
System User Manual
Thank you for purchasing our product! Please kindly read this manual carefully before use, and operate according to it correctly.
Features
- Designed for balconies, patios, small gardens without faucet and fixed power supply
- Powered by solar energy, no need for additional wiring
- Taking water directly from containers such as buckets, without the need for a tap
- Automatically watering at preset time intervals and amounts
- Automatically alarm to replenish water when water shortage in the container
- Pipes, joints and drippers are provided, you can freely match them
Packing List
Controller1
Manual1
Ground stake1
Accessories Kit1
Screw*2
Product Appearance
- Host Mainrame
- Water Pipe
- Fiter
- Outlet Pipework.
- Thee DirectLinks:
- dripper
- water level sensor
Panel Schematic
Installation Diagram
Operation instructions
- Fix the product in a position where the solar panel can be exposed to direct sunlight and the side with the switch button must be faced down. The product can be inserted into the soil by using the ground stake, o be fixed with screws on the wall, fence, etc.
- Loosen the screws of the connecting ground rod to adjust the angle of the solar panel surface, 50 that the solar panel can receive as much sunlight as possible. Then tighten the screws.
- Install the water inlet pipe, water outlet pipe, tees, drippers, filter, etc. according to the installation diagram. The watering flow of the product is about 400mL/min (that is, the sum of the water output of all drippers is 400mL/min). Please select the number of drippers and the watering frequency according to your actual water demand of flowers and plants.
- Press the ON/OFF switch button to turn on/off the product.
- Press the MODE button to select the watering frequency. For example, the blue indicator light which s in the first position (upper shows 12, lower shows 5), it means that the product will water once for 5 minutes each every 12 hours. And, each time the MODE key is pressed, the system will re-time and will water as the first position watering frequency.
- This product isPut the long-cable probe into the deep water and when the water level is lower than the short-cable probe (that is, a probe is out of the water), the system will automatically alarm (the buzzer sounds 2 times per minute) and stop working (stop watering and timing). After refiling the water, the system will continue to work as the previous watering program
- When the water pump is idling, the system will alarm (The buzzer sounds twice a minute during the day: at night only the indicator light flashes without a beep), and the green indicator light located at the MODE button will flash. The cause of this failure may be that the water pump o the fiter is blocked, please clean them; it may also be that there is no water in the water source container, please add water. You can unclog the pump by injecting some warm water into the pump inlet with a syringe (the syringe is not equipped, please purchase it separately if it needed). After troubleshooting, please restart the product, the system will perform a watering and re-time.
- When the power of the system is low, the red indicator light located at the ON/OFF button will flash. After 30 seconds, the red light will be off, and the blue gear indicator will also be off. At this time, the system enters the standby state. Later when exposed to sunlight again and the product gets fully charged, the system wil automatically return to the working state (the blue light is on). And the system will perform a watering and re-time.
Buzzer | LED Indicator | Failure description | Solution |
---|---|---|---|
Beep | 1.Pump clogged |
2. Filter clogged
3. Water shortage| 1. Unblock the water pump
2. Clean the filter
3. Add waterAfter completing the above steps, the system must be restarted
Beep| Green light steady on| Dripper clogged| Clean the dripper, restart the
system
Beep| | Water shortage| After adding water, the system will continue to work
as the previous watering program
| The red light flashes for 30 seconds and then turns off. The blue light is
also off.| Insufficient power, the system automatically enters the standby
state| After bein charged bgy sunlight, it will automatically return to
working state
Item name| Solar Automatic Watering System
---|---
Model No.| IC003S
Solar panel| 2W
Battery| 3.7V 2200mAh
Pump| 2.5W
Water flow| 400mL/min
Water sensor| YES
Operating temperature| 1-40°C
Storage temperature| -10-50°C
*Important tips
- Do not disassemble this product by yourself.
- Do not vigorously vibrate, beat or hit the product.
- Its strictly forbidden to throw this product into fire to avoid the risk of fire or explosion.
- Children should use this product under the guidance of their parents.
- When the ambient temperature is higher than 40°C or lower than 0°C, the product may fail to work, please avoid using it
- Itis forbidden to put the product into water. And the side with the switch button must be faced down, otherwise water may enter.
- Be sure to use a water fiter at the water inlet pipe interface, otherwise the main unit will be at risk of damage.
- Choose a sunny place to install the product and clean the dirt on the solar panel regularly to help improve the charging efficiency.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>