Hard Head 006402 Storage System Instruction Manual
- June 4, 2024
- Hard Head
Table of Contents
- Hard Head 006402 Storage System
- SAFETY INSTRUCTIONS
- DESCRIPTION
- ASSEMBLY
- FITTING OF HANGER PANELS
- CONNECTION OF CUPBOARDS
- REMOVAL OF DRAWERS
- FITTING OF WORKTOP
- CONNECTION OF MIDDLE AND END BRACKETS
- FITTING OF TOP CUPBOARD
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Hard Head 006402 Storage System

Jula reserves the right to make changes. In the event of problems, please contact our service department. www.jula.com
SAFETY INSTRUCTIONS
- At least two persons are needed for lifting and assembly, otherwise there is a risk of back injury or other personal injury.
- Never leave children unattended near the product.
- Do not climb, or stand on the product – risk of personal injury.
DESCRIPTION
TOOLS

- Adjustable spanner
- Spirit level with magnetic mount
- Tape measure
- Combination spanner
- Sleeve
- Set square
- Pen
- Cross-head bit
- Phillips screwdriver
- Cordless drill
- Concrete drill
MATERIAL

- Hex screw M6 x 16
- Nut M6
- Plastic plug
- Hex screw M8 x 16
- Flat washer Ø 8
- Spring washer Ø 8
- Wood screw ST6 x 16
- Countersunk screw M6 x 16
WORKTOPS

- 68 cm worktop. Fits over a cupboard
- 136 cm worktop. Fits over two cupboards
- 204 cm worktop. Fits over three cupboards
MAX LOAD

| Product | Max load (kg) |
|---|---|
| 2-door tall cupboard | 300 |
| 1-door tall cupboard | 180 |
| Top cupboard | 15 |
| Hanger panel | 10 |
| Bottom cupboard | 60 |
| Drawer unit | 150 |
| Waste cabinet | 90 |
ASSEMBLY
ASSEMBLY OPTIONS FOR CUPBOARDS

The assembly diagrams are only examples, the furniture can be configured in many different ways. Take into consideration the power points in the room when planning the configuration and assembly.
FITTING OF MIDDLE AND END BRACKETS

FITTING OF HANGER PANELS

CONNECTION OF CUPBOARDS
Position and fasten the cupboards to the wall. Fit the cupboards one by one. Adjust where necessary the four levelling feet so that the cupboards are horizontal.
Tall cupboard and bottom cupboard

Drawer unit and bottom cupboard

Bottom cupboard and brackets

Bottom cupboard and worktop

REMOVAL OF DRAWERS

Release and take out drawer by pressing the catches on the sides as show in diagram.
FITTING OF WORKTOP

- On cupboard: Hex screw M6 x 16
- On bracket: Wood screw ST6 x 16

CONNECTION OF MIDDLE AND END BRACKETS
- A. Fastening in corner not necessary.

FITTING OF TOP CUPBOARD
- Hex screw M8 x 16
- Flat washer Ø 8
- Spring washer Ø 8
- Hex screw M6 x 16
- Nut M6

- Prefit screws and washers on the panel.
- Hang up the top cupboard and tighten the screws.
NOTE:
This step applies to three types of top cupboards.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>