AUTRE BITS YYR-R1 Wireless Earbuds User Guide
- June 14, 2024
- AUTRE BITS
Table of Contents
AUTRE BITS YYR-R1 Wireless Earbuds
CONTENTS
SET BEFORE USE
CHARGING
POWER ON/OFF
CONTROLS
RESET
BATTERY INDICATOR
CLEAN
Regular cleaning is recommended to prevent issues with charging.
Thank you for purchasing the YYR R1 True Wireless Earbuds. Please read this
user manual carefully and keep it for future reference. If you need any
assistance,
please contact our support team with your product model number.
Package Contents
- True Wireless Earbuds
- Charging Case
- Silicone eartips (S /L , M come attached to the earbuds)
- USB-A to C Cable
- User Manual
Product Diagram
Product Diagram
Earbuds
| Model | YYR R1 |
|---|---|
| Technology | HFP, HSP, A2DP, AVRCP, SBC, AAC |
| Bluetooth Version | 5.0 |
| Driver (Each channel) | 1 x 10mm speaker driver |
| Sensitivity | 95dB±3dB@1KHz |
| Frequency Range | 20Hz-20KHz |
| Impedance | 32Ω±15% |
| Microphone type | MEMS (microphone chip) |
| Charging time | 1.5h |
| Playtime | 20h |
| Battery Type | Li-polymer (2 x 40mAh) |
| Operating Range | 10m |
| Weight | 7g (pair) |
Charging Case
| Charging Input | DC 5V |
|---|---|
| Charging Time | 1.5 hours |
| Battery Type | Li-polymer (300mAh) |
| Number of Earbuds Recharges: | 3-4 |
| Weight | 38g |
Getting Started
Charging
Fully charge the charging case before the first use. To charge, connect the
case to a USB charger or charging port with the included USB-A to C cable to
charge the charging case. When the LED charging indicator on the outside of
the case changes from flashing blue to solid blue, the case is fully charged.
Charging may take 1.5 hours, then case can offer fully charge to the earbuds 3
times. The earbuds should be stored in the case when not in use.
Note
- Remove the protective file from the earbuds when using for the first time.
- Using an adapter with an output voltage higher than 5V may not charge the battery or damage the device.
USB-C Charging Port
Turning On / Off
Turn On| Open the lid of the charging case and take both earbuds out, the
earbuds will automatically power on. To manually power on, tap and hold the
touch-sensitive panels for 5 seconds until the LED indicator ashes blue and
the voice guidance says “power on”.
---|---
Turn Off| Return both earbuds to the charging case and close the lid, the
earbuds will automatically power off. To manually power off, tap and hold the
touch-sensitive panel for 5 seconds until the LED indicator ashes red and the
voice guidance says “power off”. When the earbuds are not worn for about 5
minuts after being removed from the charging case, the earbuds turns off
automatically.
Pairing
Starting with the earbuds in the case:
- Open the lid of charging case and take both earbuds out, they will automatically turn on, indicators on both earbuds will flash blue and red alternately, and then enter pairing mode, the slave earbud indicator will be off.
- Turn on the pairing function via BT on the device you want to pair with the earbuds
- From the list of available devices, find and select “ YYR SONA R1”. After the connection is successful, the master earbud indicator will be off
Regular Use After Pairing
Once the earbuds are successfully paired with your device, they can be
switched on and off as follows:
- Open the lid of the charging case and take both earbuds out, then both earbuds will turn on and connect with each other automatically
- To turn off, put the earbuds back in the charging case and close the lid, They will begin charging
Using the Left / Right Earbud
Starting with the earbuds in the case:
- Take the left/right earbud out
- Turn on the pairing function on the device you want to pair with the earbud
- From the list of available devices, find and select “ YYR SONA R1”
Note
- When you turn on the earbuds, they will be automatically reconnect-ed to the previous-paired device or enter pairing mode if no paired device is found
- Either left or right earbud can be used individually once connected to your device when you keep the other one inside the charging case The wireless operating range is 10m (33ft). If you exceed this range,
- the earbuds will lose connection with your paired device. The connection will be re-established if you re-enter the wireless range within 5 minutes. Or the earbuds will be switched off automatically after 5 minutes
Reset the earbuds
- Put the earbuds into the charging case, make sure the charging case is fully charged, and then take out the left and right earbuds.
- Quickly tab the touch keys on the left and right earbuds for 6 times, and this will clear the pairing records on the device.
- Put them back into the charging case to charge, then take out the earbuds for re-pairing and connecting.
- If the reset is unsuccessful, repeat the above steps.
Controls & LED Indicators
Streaming Audio
Once paired, you can wirelessly stream audio on your device via earbuds. Music
will automatically get paused when you receive an incoming phone call and will
be resumed once the call ends.
| Play or pause music | Tap the touch-sensitive panel once on either earbud |
|---|---|
| Skip to previous track | Long press 2s on the L earbud |
| Skip to next track | Long press 2s on the R earbud |
Taking Calls
| Answer a call | Triple-tap the touch-sensitive panel on either earbud |
|---|---|
| Reject an incoming call or End a call | Triple-tap the touch-sensitive panel on |
either earbud
Activate Siri or other voice assistants| Long-press the touch-sensitive panel
on either earbud for 2 seconds
LED Indicator ( for earbuds)| Status
---|---
Solid red| Earbuds charging
Off (after charging)| Charging case fully charged
Flashing red| Battery low
LED Indicator (for case)
| red flashing 5s, then off | 10% battery remaining |
|---|---|
FAQ
The earbuds are on, but not connecting to my device For the earbuds and your
device to establish a connection, you need to put them both in pairing mode.
Please follow the instructions in the Pairing section of this manual.
I’ve connected the earbuds with my smartphone but can’t hear any sound
Double-check the volume level on your smartphone and the earbuds. Some
smartphones require you to set up the earbuds as an audio output device before
the audio can be transmitted. If you’re using a music player or other device,
please make sure it supports the A2DP profile. The sound isn’t very clear or
the caller can’t hear my voice clearly Adjust the volume on your smartphone
and the earbuds. Try moving closer to your smartphone to rule out the
possibility of interference or wireless range-related issues.
What’s the wireless range of the earbuds?
The maximum range is 10m (33ft). However, the actual range depends on
environmental factors. For optimal performance, keep your device connected
within a range of roughly 4m to 8m and make sure that there are no major
obstacles (like reinforced steel walls) between the earbuds and your device.
The earbuds won’t turn on
Try cleaning the charging the charging pins and then charging the earbuds for
a while. If the earbuds still won’t power on, please contact our support team
at the email address given in ‘Warranty & Customer Support.’
I put the earbuds back in the charging case, but the earbuds are still
connected The charging case is probably out of power. Try charging it.
Product Care & Use
- Keep away from liquids and extreme heat
- Don’t use the earbuds at high volume for extended periods, as this may
- cause permanent hearing damage or loss Regular cleaning is recommended to prevent issues with charging.
Warranty & Customer Support
For questions, support, or warranty claims, please contact your seller
directly.
Battery Warning
This product contains a built-in lithium battery. Do not expose the product to
strong sunlight or fire or it might explode. Dispose of the battery according
to local requlations. Do not dispose of it as domestic waste.
Do not remove or replace the product battery unless doing so is specified in
the User Manual or in the Quick Start Guide, or you might damage the product.
Safety Rules
- Do not disassemble or refit the earphone for any reason as you may damage it or void the warranty.
- Avoid contact with liquid to avoid serious damage to the earphone. The manufacturer does not cover water damage.
- Avoid temperatures above 75 degrees and below minus 40 degrees.
- Keep the indicator light away from children’s and animals’ eyes.
- Do not use this product during thunderstorms to avoid electric shocks.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the condition that this device does not cause harmful interference (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC’s RF Exposure quide lines,
This equipment should be installed and operated with minimum distance
between 20cm the radiator your body:
Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>