HEYMIX P202-A iPhone Fast Charger User Guide

HEYMIX P202-A iPhone Fast Charger

Product Information

• Manufacturer : Dongguan ongRi ch Electronic co.,ltd
• Model: P202-A
• Specification: 20W Smart Quick Charger
• Approved By
• Rechecked By
• Prepared By

Revision History

• Edition A.1.0
• Issue Date : 2022-11-03
• Modified content
• Initial Product Edition

Product Introduction
This product is a very small size and high efficiency 20W quick charger. It has a 2-port C+A output and uses the latest intelligent power distribution technology to achieve maximum power optimization. It is equipped with a built- in intelligent  identification chip and is compatible with mainstream fast charging protocols such as pd3.0, qc3.0, qc2.0, FCP, AFC, etc. It can be used to charge mainstream smartphones, tablets, and other digital devices that can be powered by USB-C and USB interfaces.

Electrical Specification

• Input Voltage : 100V-240V~ 50/60Hz
• Input Current : 1.0A
• Efficiency: 85%
• Standby Power Consumption : 0.10W
• Output Ripple and Noise : 200mV (Measurements will be made with an oscilloscope set to 20MHz, using a 0.1uF to 10uF capacitor)

Product Usage Instructions

1. Connect the 20W quick charger to a power outlet with an input voltage range of 100V-240V~ and a frequency of 50/60Hz.
2. Ensure that the input current does not exceed 1.0A when the charger is operating at minimum AC input and full loads.
3. The charger has an efficiency of 85% and a standby power consumption of 0.10W.
4. Connect your USB-C or USB compatible device to the charger’s C+A output ports.
5. The charger is equipped with intelligent power distribution technology, which optimizes power delivery based on the connected device’s requirements.
6. The charger is compatible with fast charging protocols such as pd3.0, qc3.0, qc2.0, FCP, AFC, etc.
7. Ensure that the device being charged is compatible with USB-C or USB interface.
8. Monitor the output ripples and noise, which should not exceed 200mV. Use an oscilloscope set to 20MHz for measurement.

Dongguan LongRich Electronic co.,ltd

Revision History

Product Introduction

This product is a very small size and high efficiency 20W quick charger.
2-port C+A output, using the latest intelligent power distribution technology to achieve maximum power optimization. Built in intelligent identification chip, compatible with mainstream fast charging protocol, supporting pd3.0, qc3.0, qc2.0, FCP, AFC, etc. It can be compatible with the mainstream smart phone, tablet and other digital devices that can be powered by usb-c and USB interface.

Electrical Specification

• Input Voltage
  • Operating voltage range and frequency 100-240V~50/60Hz
• Input Current
  • The input current should be less than1.0A, under minimum AC input and full loads.
• Efficiency
  • The power supply best efficiency shall be greater than91% under rated input voltage. It will be measured at the typical load
• Standby Power Consumption
  • Standby Power Consumption＜0.10W。
• Output Ripple and Noise
  • Output ripples and noise ≤ 200mV (Measurements will be made with an oscilloscope set to 20MHz bandwidth limit. The outputs will be bypassed with one0.1uF multilayer (type X7R) and one 10uF tantalum electrolytic (low  ESR) capacitors
• Protection
  • Short Circuit Protection, Over Current Protection, Over Voltage Protection, Over Temperature Protection, Brownout Protection.
  • V-0 PC Case
• Hold up Time
  • Hold-up time no less than 10 mS at 100 Vac input, the output loading should be set up with full load during
• Start up Time
  • Start up time no more than 1 seconds at 100 Vac input, the output loading should be set up with full load during the test

Product Specification & Quick Charging Protocol

Product Specification

• INPUT： 100－240V～ 50/60Hz 1A MAX
• TOTAL OUTPUT POWER ：20W MAX
• OUTPUTS
• USB-C : 5V 3A,9V 2.22A,12V 1.67A （20W MAX）
• USB-A : 5V 3A,9V 2A,12V 1.5A （18W MAX）
• USB-C + USB-A: 5V 3A （15W MAX）
• PPS: 3.3-11V/2.0A,

Quick Charging Protocol

• USB-C : PPS/PD3.0 /QC2.0/QC3.0/Samsung 5V-2A /Apple2.4A/DCP-1.5A
• USB- A ： QC2.0/QC3.0/Samsung 5V-2A/Samsung AFC/ Huawei-FCP SCP/MET-PE+2.0 Apple2.4A/DCP-1.5A
• USB-C+USB – A:Samsung 5V-2A /Apple2.4A/DCP-1.5A

Functions of output parameter table

Environment Requirement

Temperature

• Operating Ambient : 0-+25℃
• Non-operating Ambient : -20-+75℃

Humidity

• Operating : 20%~85%relative humidity (Non- condensing)
• Non-operating : 10%~90% relative humidity (Non- condensing)

Altitude
The equipment is only used in the area below 2000m sea level

Agency Safety
CCC CE CE (EU)2019/1782 RoHS

other

1. Product Dimensions
   • AUX
   • Size ： L36W32H47.5mm
   • Size with plug ： L36W32H64.5mm
2. USB Colour
   • TYPE-C Colour BLACK
   • USB-A Colour ; Orange。
3. Product colour : Black / white Selectable
4. Weight ：:55g
5. Outlook View

References

• 2C1A+多快充协议，麦多多65W氮化镓充电器评测（CH-790） - 充电头网

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>