K SPEAKER S7 Motorcycle Speakers Bluetooth Waterproof Radio Audio System User Manual
- June 14, 2024
- K SPEAKER
Table of Contents
K SPEAKER S7 Motorcycle Speakers Bluetooth Waterproof Radio Audio System User Manual
1. Features
Bluetooth Audio
FM radio
2. Package content
Please check whether the accessories are complete after receiving the goods.
Host x1. Power cord x1.
MS Hex Screw Driver x1.
Rubber pad x6. Nylon tie x10.
Antenna x1. M8x30 Screw x2.
Non-slip Meson x2.
Upper Bracket x2.
Lower Bracket x2.
3. Wiring
First the red end of the power cord is connected to the positive battery of the power supply, while the black end is connected to the negative. Then connect the power cord to the host.
The audio wiring should not be close to the high-voltage package and spark plug.
4. Instructions
PWR knob
- Press the knob for a short time to turn on, and press and hold for about 2 seconds to turn off.
- ln the radio mode, press the knob shortly to mute, and then press the knob shortly to release the mute.
- ln Bluetooth mode, press the knob shortly to pause, and then press again to release the pause playing.
- Rotate clockwise to turn up the volume, and rotate counterclokwise to turn down the volume. When the volume is turned to the maximum, there will be a prompt tone.
MODE knob
- Press the knob shortly to switch the radio/Bluetooth mode.
- ln the radio mode, clockwise rotation is to search for a station to the high end, and counterclokwise rotation is to search for a station to the low end.
- ln Bluetooth mode, clockwise rotation is downward music selection, and counterclokwise rotation is upward music selection.
- Turn off or turn on the modal beep
Click the mode button 3 times in a row to turn off the mode prompt sound.
On the premise of turning off the mode prompt sound, click the mode button 3 times in a row to turn on the mode prompt sound.
Bluetooth connection
To pair and connect your bluetooth device to the S7,enter the MOD knob until
you hear the voice prompt “Bluetooth mode”, which means that it has turned to
Bluetooth mode. At this time, you can use your bluetooth device to connect
with Bluetooth. After the connection is successful, you will hear the prompt
tone of “Ding Dong”.
5. Installation Instructions
6. Technical Parameters
0 p era ting vo I tag e—————————10. 5 V-1 GV
Stand by current——————————< 2mA
TH D———————————————< 1 %
S/N———————————————-> 7 Sd B
Frequency response ————————70Hz-15KHz
FM radio frequency range—————–87 .5-108MHz
Bluetooth connection distance———–>15 m
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>