RHAEGON CP12 Portable Tyre Inflator User Manual

Portable Tyre Inflator
CP12

User Manual

Portable Tyre Inflator

Thank you for purchasing mini electric air pump. Please read this user manual carefully before using this product and keep it properly for reference.

Packing list

Attention

1. Donnot leave away from the product when using.
2. The pump could be high temperature or utter a abnormal sound during using. Please turn it off to cool down. And do not use it again until it becomes cool.
3. Keep away from combustible and explosives.
4. Avoid moisture, sand and falling.
5. Do not store the product in a place that is too cold or hot. Since the inflator is equipped with lithium batteries, do not put it into fire or discard casually.
6. Supervise children not to play with the appliance.
7. The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they’ve been given supervision or instruction concerning use of the appliance 8.This appliance contains batteries that are non-replaceable.
8. Instructions for class Ill appliances state that it must only be supplied at SELV.

Specification

Instruction

1. On/Off Power on:
   Press and hold the power button for 3seconds to turn on the tyre pump.
   Shutdown:
   Press and hold the power button for 3seconds to turn off the tyre pump.

2. Battery Indicator Different colors of the power indicator Indicate different power levels:
   Green: 70%~100%
   Orange: 30%~70%
   Red: 5%~30%
   Red flash: 5% or less
   (It is in a low battery state and needs to be charged before use)

3. Start Inflation and Stop Inflation In the power-on state, short press the power button to start or stop inflating.
   It can also automatically stop inflating when the preset air pressure value is reached.

4. Charging Type-C charging input 5V 2A. Use the charging cable to connect the pump and the power adaptor  (not included) for charging.
   When the indicator bar is flashing: On Charge The color of the indicator turns to be green and stops flashing: Fully Charged
   Tips: The tyre pump cannot be used during charging.

5. Connect Valve to Hose The bicycles, electric bicycles, motorcycles, and automobiles will be equipped with Schrader valve.
   Inflation: Connect the Schrader valve to the connector on the high- pressure hose to start inflate.
   Road bikes and some other bikes need to use a Presta adaptor when inflating.
   Inflation:
   1. Connect the Presta adaptor to the connector on the high pressure hose.
   2. Unscrew the Presta cap of the tire.
   3. Connect the Presta to the connector to inflate. Balls such as basketballs and footballs, need to be filled with a ball needle.
   Inflation: After pressing the ball needle and the Schrader connector firmly, insert the needle into the filling hole of the ball to Inflate.

6. Check The Air Pressure In the power-on state, when the air tube of the pump is well connected to the target to be inflated, the real time air pressure of the target can be detected and showed on the upper place of the screen.

7. DC start
   Use the charging cable to connect the power outlet of the car cigarette lighter with the DC port [ ]of the product, then press the switch [ ] for 3 seconds to power on the air pump. You can use the cigarette lighter to supply power to the product while working.

8. Preset Modes Switching
   Short press the working mode button [ ] to switch between 5 preset inflating modes, namely:

9. Unit Switching
   Short press [ ] to switch the air pressure display unit between PSI BAR, KPA, Kg/cm². Unit conversion formula: 1BAR = 14.5PSI

10. LED Lighting
    After a long press [ ], the LED lighting is turned on, and a long press again will turn it off.

11. Preset Pressure
    Short press : Adjust the preset air pressure value +/-0.5PSI.
    Long press    : You can quickly adjust the preset air pressure value.
    Note: In the custom mode, the preset air pressure value will be automatically saved, and the next time you switch to the custom mode, the preset air pressure value will be automatically set to the last set value.

12. Calibration
    Turn on the unit and do not connect its hose to any target objects, if the dispalyed real-time air pressure value is not 0.0, press and hold the buttons

• and – for 3 seconds at the same time, then the dispalyed value will return to the correct one after all icons light up on the screen for 1 seconds
  Note: This product has calibrated at the factory. Due to altitude or sensor differences, when the measured air pressure value is not zero, manual reset can improve the air pressure accuracy.
  Calibration is not recommended at high temperature.

  13. Checking the Suggested Pressure
      In order to ensure safety, before inflating, please check the suggested tyre pressure of the inflated tyres by reading the instructions and other methods, to avoid any injury due to explosion caused by over-inflating tyres.

The air pressure range of a car tyre is marked on the side of the tyre.
The charging pressure is related to the load weight. For more detailed air pressure recommendations, please refer to the manual of the relevant vehicle.

Bicycle Tyre

The air pressure range of a bicycle tire is  marked on the side of the tyre.
The charging pressure is related to the load weight. For more detailed air pressure recommendations, please refer to the manual of the relevant vehicle.

Balls

The filling pressure of balls such as soccer, basketball, and volleyball is marked around the filling holes. The charging pressure is related to the load weight. For more detailed air pressure recommendations, please refer to the manual of the relevant balls.

Safety Precautions

When unscrewing the hose, the hose and joint will generate high temperature due to long-term work. Please do not keep in contact for a long time.

Air Pressure Value of Common Products

Troubleshooting Guide

2.Check whether the air tube is leaking.
3.Check whether the air tube is well connected with the tyre or air pump
4.Check whether the inflated targets are leaking
Unable to inflate after powered on| 1.Check whether the battery is fully charged.
2.Check whether the current tire pressure is higher than the preset value.
The preset pressure cannot be adjusted.| Check if you choose the incorrect mode, select the Custom Mode to adjust the preset value in the range of 2-160PSI.
Can inflate but the air pressure display does not change| 1.Low-pressure products such as balloons are not within the measurable range of the device.
2.In the case of an empty tyre, the tyre pressure value can be displayed after a short period of inflation.
The inflator automatically shut down after connecting hose| The pump will shutdown automatically after 3 minutes with no operation, long press the start button to restart.
There is leakage when connecting the hose| Tighten the hose
The color of the power indicators in charging state is different from that in standby state.| The power lithium battery has a significant voltage drop during the discharge process, which causes the color of the indicator light in the charging state and the standby state to be inconsistent. This phenomenon is not a malfunction.
The power indicator does not light up
while charging| Replace with a safe and compliant charging cable or adaptor to recharge.

After-Sales Service

For questions about this or any other RHAEGON Products, please email us: support@rhaegontools.com or Login our web site: http://www.rhaegontools.com

EVATOST CONSULTING LTD
Suite 11, First Floor, Moy Road Business
Centre, Taffs Well, Cardiff, Wales, CF15
7QR contact@evatmaster.com

eVatmaster Consulting GmbH
Bettinastr. 30 60325 Frankfurt am Main,
Germany contact@evatmaster.com

Manufacturer: shenzhenshichutiankejiyouxiangongsi Work address: Room 510, No. 18, Ninth Lane, Xiagongling, Xialilang Community, Nanwan Street, Longgang District, Shenzhen City, Guangdong Province, China

Made in China

Documents / Resources

| RHAEGON CP12 Portable Tyre Inflator [pdf] User Manual
CP12 Portable Tyre Inflator, CP12, Portable Tyre Inflator, Tyre Inflator, Inflator
---|---

References

• The Best Heating Tools of new era in both design and performance

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>