CISCO Room Panorama Pro Table Microphone Installation Guide
- June 14, 2024
- Cisco
Table of Contents
Room Panorama Pro Table Microphone
Installation Guide
Room Panorama Pro Table Microphone
Room Panorama and Room 70 Panorama support up to 6 Table Microphone Pro. The
Table Microphone Pro cannot be combined with other microphones.
This product must be used with the supplied table adapters to lock position
and orientation.
Cisco Table Microphone Pro
The Table Microphone Pro is a premium directional microphone. It can capture
participant voices from different directions and deliver multiple streams of
audio.
When installed correctly,
participants in the far end will hear the participants’ voices coming out of
the loudspeaker nearest to their image on the screen.
Placement plan
- You will need a table placement plan. If a placement plan has not been provided, refer to the Cisco Room Panorama Room Preparation Guidelines (https://www.cisco.com/go/panorama-installation) for more information about making your own.
Features
Choose your track
Choose one of the tracks and proceed to the indicated page. 
Refer to the placement plan. If
your table does not have pre-drilled holes, measure and mark the positions of
the holes.
Drill the holes.
Orient the adapter with the arrow.
Orientation
For microphones placed along the centerline, the arrow should point away from the screen.| For all other microphones, the arrow should point toward the participants, perpendicular to the nearest table edge.
Attach the cable cover.
Place microphone on the
adapter.
Connect the microphones to
the switch.
When the power is on, run
the microphone setup from the Settings menu on the touch controller.
Refer to the placement plan. Measure and mark the positions of the adapters.
Drill the holes. Note that the adapter
center is slightly offset from the hole.
Install the
adapter next to the hole.
Orientation
For microphones placed along the centerline, the arrow should point away from the screen.| For all other microphones, the arrow should point toward the participants, perpendicular to the nearest table edge.
Attach the cable cover.
Place microphone on the
adapter.
Connect the
microphones to the switch.
When the power is on, run the microphone setup from the Settings menu on the
touch controller.
Refer to the placement plan.
Measure and mark the positions of the adapters.
Orient the
adapter with the arrow.
Orientation
For microphones placed along the centerline, the arrow should point away from the screen.| For all other microphones, the arrow should point toward the participants, perpendicular to the nearest table edge.
Route the cable in the desired direction.
Attach the cable
cover.
Place microphone on the adapter. Connect
the microphones to the switch.
When the power is on, run the microphone setup
from the Settings menu on the touch controller.
Removing the cable cover
If you need to remove the cable cover, you can use a flat-head screwdriver in
the notch on the underside to help separate the pieces.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
https://help.webex.com
https://www.cisco.com/go/panorama-installation
Visit one of these websites to find out more about setup, management, and use
of this product. Use the first link if your device is registered to the Cisco
Webex service and the second link if the device is registered to another
service.
https://www.cisco.com/go/projectworkplace
Explore the Cisco Project Workplace to find inspiration and guidelines when
preparing your office or meeting room for video conferencing.
cs.co/webexadoption
The Webex Adoption site provides training tips, use cases and best practices
for deployment and managing change. Our toolkits make adoption easier.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco
and/or its affiliates in the U.S. and other countries. To view a list of Cisco
trademarks, go to this URL:
www.cisco.com/go/trademarks. Third-party
trademarks mentioned are the property of their respective owners. The use of
the word partner does not imply a partnership relationship between Cisco and
any other company. (1110 R)
Cisco Systems Inc.
Corporate Headquarters
170 West Tasman Dr.
San Jose, CA 95134
USA
https://www.cisco.com/go/offices
© 2023 Cisco Systems, Inc. All rights reserved.
References
- Webex Help Center
- Contact Cisco - Cisco
- Cisco Room Series - Install and Upgrade Guides - Cisco
- Cisco Project Workplace | Seamless Collaboration
- Cisco Trademarks - Cisco
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>