XISHE C-3718-5A Drafting Tall Office Standing Desk Chair Instruction Manual
- June 14, 2024
- XISHE
Table of Contents
XISHE C-3718-5A Drafting Tall Office Standing Desk Chair
Package List
-
(A)*1 Backrest
-
(B)*1 Seat
-
(C)1L 1R Armrests
-
(D)*1 Mechanism
-
(E)*1 Gas Lift
-
(F)*1 Base
-
(G)*5 Legs
-
(H)*5 Casters
-
(I)*4 Bolts
-
(J)*6 Bolts
-
(K)*10 Bolts
-
(L)*4 Bolts
-
(M)*1 Wrench
-
(N)*1 Foot Ring
Assembly Instruction
-
Turn the Base (F) upside down, insert the Legs (G)5 into the Base one by one. Use Wrench (M), secure both with Bolts (K)10.
-
Press Casters (H)5 into the holes at the end of Legs (G)5
-
Insert Gas Lift (E) into the center hole of the Foot Ring (N) and lift the Foot Ring upward to secure it to the Gas Lift. Then insert Gas Lift (E) into the Base (F). Remove the cover from the top of the Gas Lift (E).
-
Using Wrench (M), install Armrests (C)1L1R to both sides of the Backrest (A) with Bolts (I)*4.
NOTE: -
.Bolts (I) are only tightened 50%.
-
.Armrests (C)1L1R are marked with “L” (Left) and “R” (Right) to show which side they should be installed.
-
Turn the Seat (B) upside down . Using Wrench (M), install Armrests (C)1L1R to the Seat with Bolts (J)*6.
NOTE:
The Seat (B) is marked with “FRONT”, please make sure the installation direction is correct. -
Using Wrench (M), attach Mechanism (D) to the Seat (B) with Bolts (L)*4.
NOTE:
Make sure the “FRONT” direction of Mechanism (D) and Seat (B) are the same.
-
Align the hole on Mechanism (D) with Gas Lift (E), and press the Chair down until it is fully secured. Using Wrench (M), 100% tighten the previously installed Bolts (I)4 on the Armrests (C)1L*1R.
-
Finish the installation.
Instructions For Use
To raise:
While taking your weight off chair, lift lever up.
To lower:
While seated, lift lever up.
CAUTION:
- Before using the chair, check to ensure that all bolts are fully tightened.
- Lubricate all parts and tighten all bolts every 6 months or whenever needed.
To deodorize the leather leave the chair in a shady outside for 1-2 days.
For longer use
Re-tighten bolts every 6 months by using the enclosed allen-key.
*Using an electric drill can damage the chair. Please re-tighten bolts manually
Safety Information
Sit in the center of the chair, with your back to the backrest
Do not sit at the front edge of the chair
Do not stand on the chair
Do not use the chair with more than one person
Do not push the chair around when a person is sitting in it
Do not push down on the backrest when a person is reclined
Do not place all your weight on only the backrest
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>