CLAONER A1O Outdoor Solar Light User Manual
- June 14, 2024
- CLAONER
Table of Contents
CLAONER A1O Outdoor Solar Light
Installation
Press the button on the back and select the mode you want. Then choose a place that can get enough sunshine to install this light. The longer it gets sunshine, the longer the lights can last.
- Fix The Base (pic 1): Punch two holes on the wall with a drill bit, insert the attached expansion pillar- hinge into the holes, and drill the screws through the base into the wall.
- Choose The Angle, Install The Light (Pic 2): Attach the adjustable pivot arm to the base, adjust to the desired angle, and then tighten it through the knob screw.
Operation Guide
- No light during the day in any mode bright at night During the day test, please cover the solar panel and keep it in a dark environment, otherwise the light will not be on.
- The default mode of the product is OFF mode. Click the black button on the back of the light panel, each press the black button will change one mode. Mode set in the cycle (Mode1-Mode2-Mode3-Mode4-off).
Lighting Modes
Mode 1: Light Control Mode Press the button once to activate Light Sensor
Mode. The light automatically switches to 50% brightness when it gets dark or
at night. The light switches off automatically at dawn.
Mode2: Dim Light Sensor Mode Press the button twice time to enter low
brightness sensing mode. At night or when it’s dark, the light automatically
switches to low brightness sensing mode. If someone is detected within the
detection range, it switches to high brightness mode. If there is no movement
for about 20 seconds, it automatically returns to low-brightness sensing mode.
Mode3: Strong Light Sensor Mode Press the button a third time to enter
high light sensor mode. The light will not come on at night or in the dark
when no motion is detected. If someone is detected within the detection range,
the light will come on at high brightness. It switches off automatically after
about 20 seconds if no movement is detected.
Mode4: SOS Flashing Mode Press the button a fourth time to enter SOS
flash mode.Flashes throughout the night to alert people.
Warm Tips
- It is recommended to turn off the light and charge in the sun for 1-2 days before first use, otherwise, insufficient power will affect the use time.
- Place the solar panel in a sunny place with no obstacles, with the front of the solar panel facing the sunniest angle.
- Please avoid direct light on the solar panel at night. Otherwise, the light sensor judges that it is daytime and the light will not light up.
- Whether the LED solar sensor wall light can produce the best lighting effect or not depends on the sunshine intensity, geography- cal location, weather conditions, seasons and other conditions.
Two Ways to Change Modes:
Click the black button on the back of the light panel, each press the black
button will change one mode. Mode set in the cycle (Mode1-Mode2
-Mode3-Mode4-off).
Change mode with Remote control. But you must activate the lights by clicking
the button on the back of the lights.