RALPH LAUREN RL 2280 Alessandra Large Chandelier Sconce Instruction Manual
- June 4, 2024
- ralph lauren
Table of Contents
RL 2280 Alessandra Large Chandelier Sconce
Instruction Manual
ASSEMBLY INSTRUCTIONS
Alessandra Large Chandelier
Sconce
Item # RL 2280
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install it.
Retain all packaging material until installation is complete and approved.
-
Carefully remove all parts from the box.
-
Remove the mounting plate (C) from the fixture body (G) by loosening side screws (B).
-
Affix mounting plate (C) onto the outlet box and secure with mounting screws (D).
-
Attach the rubber washer (N), and crystal disk (F) to the threaded nipple (O) and secure with rubber washer (M), and finial (L).
-
Attach the crystal disk (J) to the threaded nipple (K) and secure with crystal column (I).
-
Remove the candle tube (Q), let the crystal disk (H) pass through the socket, then put the candle tube (Q) into the socket.
-
Connect the hot wire (smooth edge, markings) from the fixture to the hot wire from the outlet box (usually BLACK). Fasten them together with a plastic wire connector (A) provided and wrap the connection with electrical tape.
-
Connect the neutral wire (ribbed, no markings) from the fixture to the wire from the outlet box (usually WHITE).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED. -
Connect the ground wire from the fixture (bare copper) to the ground wire from the outlet box (usually green or copper in color).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED. -
Attach the fixture body (G) onto the mounting plate (C) and secure it with side screws (B).
-
Hang the crystal drop (E) to the final (L).
-
Hang the crystal drops (X) to the crystal disk (H & J), then hang the crystal drops (Y) to the crystal disk (F).
-
Put the flower drops (Z) to the center of the fixture body (G), then hang the crystal drop (W) to the two arms.
-
Insert bulbs (not included) into the sockets.
-
Installation is complete, turn on the power at the fuse or circuit breaker.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>