MLDKA MQ-21 Wrist Shaped Animal Shaped Walkie Talkie Instructions
- June 15, 2024
- MLDKA
Table of Contents
Wrist-shaped animal-shaped
walkie-talkie
How to operate
- Press and hold for 5 seconds “ ” to turn on/off
- Long press for 3 seconds “V+/V-” to change different channels and light colors. When the light color is consistent, press “V+/V-” to adjust the volume for the same frequency
- When the same frequency is successful, press and hold “TALK” to speak
- “CALL” is the call button, you can call the other party in the same frequency state, and the other party can answer the call after pressing “CALL” after receiving the call
Product parameters
Working voltage: 4.5V
Transmission power: 0.5W
Standby current: 10mA
Frequency: 162. 5625-162. 6125MHZ
Receiver sensitivity: less than -120dBm
Transmission current: 300mA
Battery life: 48 hours
Each intercom uses 3 AAA batteries Effective straight-line communication
distance: 1000 meters
Friendly reminder: When the walkie-talkie is not in use for a long time,
please remember to turn it off to save power.
Attention:
This radio complies with IEEE and ICNIRP exposure limits for General
Population/Uncontrolled RF exposure environment at operating duty factors of
up to 50% and is authorized by the FCC for General Population/Uncontrolled use
only. An appropriate
warning lable is affixed to all units. In order to comply with RF exposure
requirements, a minimum distance of 10 mm must be maintained when held-to-face
and 0 mm must be maintained when next to Limb. Do not use this device when
antenna shows obvious damages.
This product is compliance to FCC RF Exposure requirements and refers to FCC
website
https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm search for FCC ID:
2BCOJ-MQ-21 to gain further information include SAR Values.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>