Nisorpa G25 PC USB Simulate Linear Handbrake Instruction Manual
- June 13, 2024
- Nisorpa
Table of Contents
Nisorpa G25 PC USB Simulate Linear Handbrake
User interface
When you receive USB handbrake, please do the following steps first
-
First plug USB cable of handbrake to PC ,then click “ Devices and Printers ”
-
Right Click “ Arduino Micro ”
-
Click “ Properties ”
-
Click “ Settings ” first ,then click “ Reset to default ”
-
Click “ Calibrate ”
-
Click “ Next ”
-
when you see this ,just pull the handbrake from the start to the end .
-
Then click “Next” and “Finish”
-
Then click “Test” and Pull the handbrake ,you will see Throttle moving fromthestart to the end .Then click “OK” ,Enjoy your game !!!
Dear Customer ! Our USB PC handbrake nearly supports all racing
games(Becausethere are so many racing games ,we have no ability to test them
all ,We are sorry for this and please understand us) It supports the handbrake
for some games originally ,for these games you just need to set it on the game
. If you meet the games which is not supported originally ,you could use this
softwarenamed“Joy to key”.You could google and download it from internet .The
functionof this software is to make handbrake control the key of the keyboard
(For exampleyou could use handbrake to type out W key in the keyboard. Nearly
every racinggames that could be controlled by the keyboard .) I give you an
example .You coulddo like this .First Set key W to control the function of
handbrake on the game ,thenusing the software “Joy to key”to make handbrake to
control key W. Doing like this ,handbrake could control the game which doesnt support originally . If you have any questions about “Joy to key” that you don
t know howto do it ,youcould ask us or google it . Wish you have a nice
day !
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>