VisionNet RJ45 Wire Tracker Instruction Manual

: June 13, 2024
: VisionNet

Table of Contents

Overview
Product feathures
Product introduction
Interfaces
Operation Instruction:
Rj45 Cable Wire map Test
Telephone Line Condition & Polarity Test:
Package content
Technical parameters
Read User Manual Online (PDF format)
Download This Manual (PDF format)

your excellent helper in cable test!
p.n.900226
RJ11/RJ45 Wire Tracker
INSTRUCTION MANUAL

VER:V2

Overview

It is a new wire tracker ,which consist of a transmitter and receiver. It can be used to trace Network cable and Telephone cable ,and identify cable’s continuity qualick. It’s an ideal netowork tool for the person who work with communication and intergrated wiring

Product feathures

Tracing network & telephone line cable.
Check network cable continuity.
Identify telephone cable condition & polarity.
Power system: DCS9V battery.

Product introduction

Transmitter: Tone generator
a. RJ45 and RJ11 standard modular jack
b. 3-position mode switch (OFF, CONT and SCAN).
c. 2-led displays (CONT, TONE)1~8, G Led.
Receiver: Amplifier probe
a. Use the Amplifier and tone gernerator set to quickly and accurately trace and identify wires or cables, even when in a bundle.
b. Adjust volume level (0~8) for various work environments.
c. Plug receptacle for earphone.
d. Signal LED.

Interfaces

Operation Instruction:

Cable Tracing function(eg : Network cable)

The tested cable should insert into the RJ45 port with the transmitter;
Put the button to “SCAN ” postion on the main tester , if the scan indicator lights up, that means the battery power is properly;
Press the “SCAN” button on the receiver , and trace the connected cable on the main tester If the voice is not hear clearly , should adjust the volume from 1-8.
During the testing , if you can’t find the target cable easily , please insert the earphone and separate the surrounding lines because they are too close to each other and there will be signal interference that prevents you from finding the target cable;
When you work in noisy or dark environments , you can turn on the switch on the right of the receiver.

Caution : Never connect live circuit (>60V DC)to the RJ11 or RJ45 port avoid burn out the device !

Rj45 Cable Wire map Test

Insert the two ends of the network cable to be tested into the corresponding ports of the transmitter and receiver respectively.
Turn the function switch of the transmitter to the “CONT” position, and the line sequence indicator light ﬂashes, it means that the transmitter is working normally.
Judging the physical state of the cable (such as short, open and cross circuit) by observing the indicator lights.

Telephone Line Condition & Polarity Test:

Turn on the button to “SCAN’ position , connect your telephone cable into RJ11 port on the emitter;
The SCAN LED will indicate the line condition as GREEN/RED LIGHTING = CLEAR ,FLICKERING GREEN / RED O= BUSY , OR FF (NO LIGHT ) = RINGING;

Polarity Test:

Turn on the button to ° OFF” position ( middle of the CONT and SCAN );
Insert the Crocodile clips cable into RJ11 port of the main tester, then connect the tested cable with the red and black clips seperatly;
The test result:
RED LIGHTING = POSITIVE ( Red clip connected cable is positive if SCAN light flashing )

GREEN LIGHTING = NEGATIVE ( Red clip connected cable is negative if SCAN light flashing )