NAVAC NEF6LM Break Free Power Flaring Tool User Manual
- June 13, 2024
- NAVAC
Table of Contents
NAVAC NEF6LM Break Free Power Flaring Tool
Safety Guide
Caution : Read this manual thoroughly before using.
- Keep the working area clean and tidy.
- Do not operate while under the influence of alcohol.
- Keep children and untrained people from using.
- Use original parts and auxiliary.
- Long time using may overheat its motor which activate overheat protection.
- Temperature higher than 158° F (70°C) or lower than 41°F {5°C)may activate the motor overheat or subcooled protection.
- Don’t dismantle NEF6LM at random which may void warranty.
- Product is warranted against defects in materials and workmanship for two years from the date of purchase.
- Dispose the battery according to local regulations.
- Pending patent.
Structure
Technical Parameters
| Model | NEF6LM |
|---|---|
| Tubing Type | HVACR or Soft Copper |
| Tubing OD | 1/4″, 3/8″, 1/2″, 5/8″,3/4″ |
| Power | DC motor |
| Cone Speed | 120 RPM |
| Battery Capacity | Up to 100 flares per charge |
| Time to Flare | Complete a flare in < 30 seconds |
| Dimension | 10″x4″x4″ (265x101x100mm) |
| Weight | 2.9 lbs (1.3kg) |
Battery pack
| Battery | 7.4V 2Ah 14.8Wh |
|---|---|
| Quick Charge | 30 minutes |
| Ambient Temperature | 41°F-104°F (5°C-40°C) |
Charger
| Power Supply | AC 100-240V (50/60Hz ) 50W |
|---|---|
| Output Voltage | 8.4V |
| Output Current | 3.5A |
| Ambient Temperature | 41°F-104°F (5°C-40°C) |
Light/Hold 2s to Reset Button:
- Press to show battery life.
- Press to turn on/off the light.
- Press 2 seconds to reset (draw back) the cone.
Operation Instruction
-
Deburr and clean tubing before flaring
-
Get the clamp placed.
-
Open the clamp by pressing the legs and insert the tubing.
-
Use the baffle to set the correct depth of the tubing.
-
Get the clamp placed.
-
Keep the lever open and put in the clamp. A locked lever resists the clamp being placed.
-
Push the lever inward to lock the clamp.
-
Caution:
Press the START button to flareand damage the clamp. -
Don’t open the lever during flaring, otherwise the automatic flaring stops.
-
If it happens, press the reset button 2 seconds to draw back the cone.
-
Make sure the clamp is still horizontally placed.
-
Press inward the lever to lock the clamp again.
-
Press the start button to reflare.
-
It takes less than 30 seconds to complete a flare automatically.
-
After the flaring indicator turns off, open the lever.
-
Remove the clamp and tubing.
Battery Charge
- Charge battery when the last indicator flashes which means low battery.
- Make sure the battery pack is connected properly.
- Place back the battery pack.
Troubleshooting
Caution:
- To tighten the lock, loose the locking nut first.
- Then turn the bolt clockwise 30 degree each time to check the tightness.
- Don’t turn clockwise too much each time because it may over-tight the lever and cause damage.
Exploded View
Spare Parts List
| Ref No. | Part No. | Item |
|---|---|---|
| 1 | PNEF1 | Screw |
| 2 | PNEF2 | Screw |
| 3 | PNEF3 | Riaht Cover |
| 4 | PNEF4 | Plate |
| 5 | PNEF5 | Chamber Assemblv |
| 6 | PNEF6 | Axis Assembly |
| 7 | PNEF7 | Turbine Bushina |
| 8 | PNEF8 | Bearing |
| 9 | PNEF9 | Transmission Chamber |
| 10 | PNEF10 | Circuit Board |
| 11 | PNEF11 | Disolav Panel |
| 12 | PNEF12 | Bushing |
| 13 | PNEF13 | Subolate |
| 14 | PNEF14 | Stop Pin |
| 15 | PNEF15 | Pin |
| 16 | PNEF16 | Front Cover |
| 17 | PNEF17 | Screw |
| 18 | PNEF18 | Cover |
| 19 | PNEF19 | LED Plate |
| 20 | PNEF20 | Ring |
| 21 | PNEF21 | Strao |
| 22 | PNEF22 | Screw |
| 23 | PNEF23 | Batterv Pack |
| 24 | PNEF24 | Dead Plate |
| 25 | PNEF25 | Circuit Board |
| 26 | PNEF26 | |
| 27 | PNEF27 | Bushina |
| 28 | PNEF28 | Pin |
| 29 | PNEF29 | Button |
| PNEF30 | Screw | |
| 31 | PNEF31 | Sorina |
| 32 | PNEF32 | Screw |
| 33 | PNEF33 | Screw |
| 34 | PNEF34 | Switch |
| 35 | PNEF35 | Sorina |
| 36 | PNEF36 | Lever |
| 37 | PNEF37 | Circuit |
| 38 | PNEF38 | Wire |
| 39 | PNEF39 | Screw |
| 40 | PNEF40 | Bushina |
Failure to follow warnings could result in death or serious injury.
SAVETHIS MANUAL FOR FUTURE REFERENCE
NAVAC Inc.
www.NavacGlobal.com
Tel/Fax: +1 877 MY-NAVAC 877 696 2822
MADE IN PRC
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>