TECHKO SKL-501 Solar Wall-Pillar Light User Manual
- June 13, 2024
- TECHKO
Table of Contents
Solar Wall Pillar
USER MANUAL
Model: SKL-501
SKL-501 Solar Wall-Pillar Light
Please carefully read this manual before using the product.
Keep the manual with you for reference as needed.
PLEASE FULLY CHARGE THE PRODUCT BEFORE USING
- Secure the unit and fully charge in direct sunlight and select desired operating mode(flame or still) before use.
- Charging time may vary depending on the weather, temperature and seasons.
- Do not place the product indoors or any place where there is no direct sunlight, the product will not charge properly.
- Keep the solar panel clean to ensure the product can be properly. charged. Freque_ntly clean the sola_r pane_l as needed. Avoid scratching on the panel or it may lower charging efficiency.
INSTALLATION INSTRUCTIONS
OPTION #1 (Lam (Please see Figure A for reference)
- Connect the solar torch light main body to thi lied supplied lamp base.
OPTION #2 (Wall with Bracket Kit)
-
Place the mounting sticker in a location where the product will be installed to.
Then drill 2 holes into the guides shown on the mounting sticker. -
Insert the supplied anchors into the drilled holes.
-
Place and align the wall bracket against the wall and then use a screwdriver to secure the bracket with the provided screws.
Adjust the provided wing nut and the unit bracket to the desired length and then tightly zz(x;rrea Make sure the unit bracket is pointing upward. -
Push the back of the solar unit against the unit bracket, then slide the um.gdown to secure the unit to the bracket.
Please install the unit in a place where the solar panel can be continually
exposed to the sun.
Avoid placing the unit where shade from buildings or objects would block the
solar panel.
SWITCH & FUNCTIONS
(Please sea Figure B for reference)
- Flame Mode: Slide switch to the “Flame” position. The light will illuminate with a flickering flame effect.
- Still Mode: Slide switch to “Still” position, the light will stay illuminated. Please note all LED’s will not be illuminated in this setting.
- 0ff Mode: Slide switch to the “Off” position, the light power is off.
The switch is on the top of the solar unit.
The product can be charged in all operating modes.
The solar panel is equipped with daylight sensor.
The product will charge in direct sunlight during the daytime and
automatically turn on at dusk.
WARNING & NOTICE
- Do not look directly at the LED light for a long period of time or it may damage your eyes.
- Do not attempt to disassemble or remodel the product. Any changes can be dangerous and will void the warranty.
- Please keep the product away from flammable items, explosion or Injuries may occur.
- Please switch to the OFF position when the unit is not in use for a long period of time.
PRODUCT SPECIFICATION
| Material | ABS | Solar Panel | 2.2×2.2 inch x3pcs/ 1W |
|---|---|---|---|
| Battery | Li-ion battery 18650 2200mAh | Waterproof | |
| Performance | IP65 | ||
| Size | Main body: 7.6×7.6×15.23 inch | ||
| Lamp base: 3.94×3.94×2.41 inch | Accessories | 1*Light main body |
lLamp base
1Bracket kit
1User manual
1Mounting sticker
2Screws/2Anchors
This product has a 1-year limited warranty. For further information please
visit our website at www.techkogroup.com
Copyright Reserved
Patent Pending: US 16/279.107;CN201920118689.6
support@techkogroup.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>