ECOFLOW ECO-200-P-02 Pandora Pedestal Instruction Manual
- June 13, 2024
- ECOFLOW
Table of Contents
ECOFLOW ECO-200-P-02 Pandora Pedestal
Product Information
- Product Name: Pandora Pedestal
- Model Number: ECO-200-P-02
- Overall Footprint: 400mm x 315mm
- Waste Chute Position (from wall): Approx. 245mm to the center of the chute
Product Usage Instructions
- Check if all the parts shown in the diagram are packed. If any parts are missing, contact the supplier.
- Install the waste chute on the floor.
- Assess the best position for the mounting brackets within the mounting bracket locations on the floor template.
- Drill holes through the chosen positions and insert the provided anchors.
- Using the metal washers and mounting bracket screws, securely screw down the brackets.
- Place the pedestal over the brackets and waste chute.
- Put plastic washers onto the mounting pedestal screws and drill them through the holes on the sides of the pedestal into the mounting brackets.
- Place screw caps over the mounting pedestal screws.
- Check if the pedestal is secure and firmly in place. If not, tighten the screws further.
Contact EcoFlo for further assistance:
- Website: www.ecoflo.com.au
- Phone: 1300-138-182
FLOOR TEMPLATE
FRONT OF PANDORA PEDESTAL
- Check this template is correctly scaled by measuring length and width as shown. Replace this template if the dimension is ± 1mm. This template is the minimum clearance from the wall.
- Place the template on the floor in the approximate position, then place the pedestal on the template and confirm the pedestal location is suitable. Check no joists, pipes, or cables are under the cut area.
- Align the template to the pedestal by matching the hatched pattern to the internal pedestal hole. Keep the template axis square to the wall.
- Pin or tape the template to the floor, then remove the pedestal.
- Cut out a hole along the outer ring, keeping the cut within the line width (or scribe through the template to mark the floor if the cut cannot be made with a template in position.)
- Insert chute to check hole shape
INSTALLATION INSTRUCTIONS
Please check if all the parts shown in the diagram are packed. If there are any parts missing, please contact the supplier
- Flat concrete floor
- Anchor
- Mounting bracket
- Metal washer
- Mounting bracket screw
- Plastic washer
- Mounting pedestal screw
- Screw cap
STEPS
- The waste chute should be installed on the floor.
- Assess the best position for the mounting brackets within the mounting bracket locations on the floor template, then drill holes through them into the floor and insert the anchors.
- With the metal washers and mounting bracket screws provided, screw the brackets down.
- Put the pedestal into position over the brackets and waste chute.
- Put the plastic washers onto the mounting pedestal screws and drill them through the holes on the sides of the pedestal into the mounting brackets.
- Place the screw cap over the mounting pedestal screw.
- Check to see if the pedestal is secure and firmly in place. If it is not, check the screws and tighten them further.
www.ecoflo.com.au
PH 1300-138-182
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>