Shenzhen Zechuanghai Electronic Technology 220224 Wii Remote + Wii Nunchuk Game Controller User Guide
- June 4, 2024
- Shenzhen Zechuanghai Electronic Technology
Table of Contents
Zechuanghai Electronic Technology 220224 Wii Remote + Wii Nunchuk Game
Controller
User Guide
Controller diagram
Connect to the Wii
Push the small red button on the controller (where the batteries go) then push the red button on the Wii console (under the little door), then you’re able to synchronize with Nintendo Wii.
please note
- Recommended distance for using the cursor: 50cm–6m (visual sensitivity change).
- Recommended distance for using the sound: >6m (without obstacles)
Connect to the Wii U
Turn on Wii U to be booted into the main interface. Press the white SYNC
button on the front of the Wii U console, and later install the batteries into
Wii remote, connect the Nunchuk, and press the Sync button(red button, where
the batteries go), then you’re able to synchronize with Nintendo Wii U.
If you need extra help, please contact
This device complies with part 15 of the FCC Rules. Op eration is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired opera on.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide seasonal deprotection against harmful interference cancer nearside ntia installation. This equipment generates, and usesandcan radiates radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guar Sangeetha interference evil, not CCUrina party clarinet all on. If the equipment is into essay sea refuses line reference or audio article misconception, which can best ermine turning the Equi me, not fandom n, the user sent our aged to try to correct thein different boy norm or of following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>