Shenzhen Yihong Precision Mould Y07 3 In 1 Magnetic Wireless Charger Instruction Manual
- June 13, 2024
- Shenzhen Yihong Precision Mould
Table of Contents
Shenzhen Yihong Precision Mould Y07 3 In 1 Magnetic Wireless Charger
Product Information
- Product Name: Magnetic Wireless Charger
- Quantity: 1
- Charging Power: 9V/2A or 9V/2.22A
- Charging Speed: 2.5W
Product Usage Instructions
- Connect the Magnetic Wireless Charger to a power source using the provided cable.
- Ensure that the power source supports either 9V/2A or 9V/2.22A output.
- Place your compatible device with wireless charging capability on top of the charger.
- Ensure that the device is properly aligned with the charging area of the charger.
- The magnetic attraction will help secure the device in place for efficient charging.
- Once the device is in place, the charging process will begin automatically.
- Monitor the device’s charging status to ensure it is charging properly.
- Once the device is fully charged, remove it from the charger.
- Disconnect the Magnetic Wireless Charger from the power source when not in use.
COMPATIBLE DEVICES
- iPhone 15/14/13/12 & other phone with magnetic case
- AirPods 2nd (Wireless version) / AirPods Pro / AirPods 3nd (Magsafe version) & other Qi enable Bearbuds
- Apple Watch
PACKING LIST
- Magnetic wireless charger X 1
- charging cable & wall charger X 1
- User manual X 1
Parameters
- Input Voltage: 9V/2A or 9V/2.22A
- Phone Port Output: 10W
- Earbuds Port Output: 5W
- Watch Port Output: 2.5W
Instructions For Use
- After the cable and wall charger is pluged The Blue indicator light will be on all the time. If the light is not on, please make sure the cable is fully plugged.
- If you prefer to wear a case for your phone, please make sure it’s a magnetic case.
- The charging station required enough input to charge 3 devices well. Please use a wall charger (Adapter) which is 9V/2A(18W) or above.
FCC
FCC statement:
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed toprovide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
the device, a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.