TECHKO SSL-303 Solar Wall Light User Manual

TECHKO SSL-303 Solar Wall Light

• Please carefully read this manual before using the product.
• Keep this manual with you for reference as needed.

PLEASE FULLY CHARGE THE PRODUCT BEFORE USING

1. Please turn “ON” the product and fully charge under direct sunlight before use.
2. Charging time may vary depending on the weather, temperature, and seasons.
3. Do not charge the product indoors or any place where direct sunlight can’t reach. Otherwise, the product will not charge properly.
4. Please keep the solar panel clean to make sure the product can be properly charged. Frequently clean the solar panel as needed. Avoid scratching on the panel or it may lower charging efficiency.

INSTALLATION INSTRUCTIONS

The product can be vertically hung and be installed in two different ways.
Please make sure the location where the unit is to be installed has enough space for it to fit in before installing.

OPTION #1 (Direct Mount)

1. 1. Place the mounting sticker in a location where the product will be installed to.  

   Then drill 2 holes into the guides shown on the mounting sticker.

2. Insert the supplied anchors into the drilled holes.

3. Use a screwdriver to secure the supplied screws into the anchors. Leave enough of the screw threads exposed as this will be used to mount the unit.

4. Hang the unit vertically on the installed screws corresponding to the holes behind the unit.

OPTION #2 (With Bracket Kit)

1. Place the mounting sticker in a location where the product will be installed to.
   Then drill 2 holes into the guides shown on the mounting sticker.

2. Insert the supplied anchors into the drilled holes.

3. Mount the wall bracket against the wall and then use a screwdriver to secure the bracket with the provided screws. Adjust the provided wing nut and the unit bracket to the desired length and then tightly secure.
   Make sure the unit bracket is pointing upward .

4. Push the back of the solar unit against the unit bracket, then slide the unit down to secure the unit to the bracket.

5. Please install the unit in a place where the solar panel can be continually exposed to the sun .

6. Avoid placing the unit where shade from buildings or objects would block the solar panel.

Switches & Functions (Please see Figure A for reference)

Switch A (Power On/Off)

1. ON: slide Switch A to the “ON” position to turn on the light. Please turn the product “ON” to charge the product.
2. OFF: slide Switch A to “OFF” position to turn off the light. While in the “OFF” position the unit will not charge.

Switch B (Selecting operating modes)

1. White: slide Switch B to the “White” position, the light will illuminate with a bright white light.
2. Amber: slide Switch B to the “Amber” position, the light will illuminate with a warm amber light.

WARNING & NOTICE

• Do not look directly at the LED lights, or it may damage your eyes.
• Do not attempt to disassemble or remodel the product. Any changes can be dangerous and will void the warranty.
• Please keep away from any flammable items, or explosion, property damages, or casual injuries may occur.
• Please install the product according to the user manual.

PRODUCT SPECIFICATION

2Screws / 2Anchors
1 Mounting sticker
1 Bracket Kit
1 *User manual

This product has a 1-year limited warranty. For further information please visit our website at www.techkogroup.com
Copyrights Reserved
Patent Pending : us 16/412,865

Customer Support

1-888-883-2456 
support@techkogroup.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>