TECHKO SKL-502 Solar Wall Pillar User Manual

Table of Contents

TECHKO SKL-502 Solar Wall Pillar

TECHKO SKL-502 Solar Wall Pillar

Do not look directly at the LED light for a long period of time or it may damage your eyes.
Do not attempt to disassemble or remodel the product. Any changes can be dangerous and will void the warranty.
Please keep the product away from flammable items, explosion or injuries may occur.
Please switch to the OFF position when the unit is not in use for a long period of time.

PRODUCT SPECIFICATION

Material	ABS	Solar Panel	2.2×2.2 inch x3pcs/ 1W
Battery	Li-ion battery 18650 2200mAh	Waterproof Performance	p

I 65

1 *Bracket kit

Please carefully read this manual before using the product .
Keep the manual with you for reference as needed.
PLEASE FULLY CHARGE THE PRODUCT BEFORE USING

Secure the unit and fully charge in direct sunlight and select desired operating mode (White or Amber) before use.
Charging time may be vary depending on the weather, temperature and seasons.
Do not place the product indoors or any place where there is no direct sunlight. The product will not charge properly.
Keep the solar panel clean to ensure the product can be properly charged. Frequently clean the solar panel as needed. Avoid scratching on the panel or it may lower charging efficiency.

OPTION # 1 (Lamp)

Please see Figure A for reference)
Connect the solar torch light main body to the supplied lamp base.

OPTION #2 (Wal I with Bracket Kit)

Place the mounting sticker in a location where the product will be installed to.
Then drill 2 holes into the guides shown on the mounting sticker.
Insert the supplied anchors into the drilled holes.
Place and align the wall bracket against the wall and then use a screwdriver to secure the bracket with the provided screws.
Adjust the provided wing nut and the unit bracket to the desired length and then tightly secure, Make sure the unit bracket is pointing upward.
$OPTION #2 $Wal I with Bracket Kit$$
Push the back of the solar unit against the unit bracket, then slide the unit down to secure the unit to the bracket
$OPTION #2 $Wal I with Bracket Kit$$

Please install the unit in a place where the solar panel can be continually exposed to the sun.
Avoid placing the unit where shade from buildings or objects would block the solar panel.
Switches & Functions (Please see Figure B for reference)

Slide the switch to the desired position.
a. White – Changes the lights color to a bright white light
b. Amber – Changes the lights color: to a warm amber light
c. Off – Move the switch to the center to turn the solar light off.
Even when the unit is on White or Amber settings during the daytime, it won’t illuminate as the solar panel is equipped with a daylight sensor: The product will automatically charge during the daytime and turn on at dusk or when surroundings turn dark.

The switch is on the top of the solar unit.
The product can be charged in all operating modes.
The solar panel is equipped with daylight sensor.
The product will charge in direct sunlight during the daytime and automatically turn on at dusk.