otti led-mf9045b Framed LED Mirror Installation Guide
- June 13, 2024
- otti
Table of Contents
otti led-mf9045b Framed LED Mirror
Device is for indoor use only
This light must be installed in accordance with current AS/NZS wiring rules.
This device contains no serviceable parts.
If the supply cord is damaged it must be replaced by the manufacturer, its
service agent or similar qualified persons in order to avoid potential hazard.
CONDITIONS:
- Items must be installed by a licensed tradesperson only,
- The installation of the product is in accordance with the instructions provided.
LED MIRROR INSTALLATION
Notes: This device contains no serviceable parts.
If the supply cord is damaged it must be replaced by the manufacturer, its
service agent or similar qualified persons in order to avoid potential hazard.
-
Parts Included
-
Measure screw hole locations on bracket
-
When marking for screw, ensure level with mirror rear bracket
-
Drill holes for mounting screws provided, ensure these are drilled into supporting wall (through masonry, brick wall or noggins to support the cabinet load).
-
Drill the screw into the wall
Check Products For Any Damages
Wiring from light fitting
Device is for indoor use only.
This light must be installed in accordance with current AS/NZS wiring rules.
This device contains no serviceable parts.
If the supply cord is damaged it must be replaced by the manufacturer, its
Check Products For Any Damages
Wiring from light fitting
Device is for indoor use only.
This light must be installed in accordance with current AS/NZS wiring rules.
This device contains no serviceable parts.
If the supply cord is damaged it must be replaced by the manufacturer, its
IMPORTANT CONDITIONS Please inspect thoroughly before installation to
ensure that the product has not been damaged and is correct.
No claims for damage or incorrect items will be recognised after installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>