NELSON-RIGG NR-215 Weekender Backrest Rack Bag
- June 13, 2024
- NELSON-RIGG
Table of Contents
NELSON-RIGG NR-215 Weekender Backrest Rack Bag
Product Information
The NR-215 Weekender is a bag designed for outdoor use, specifically to protect your belongings from inclement weather. It comes with a rain cover included to ensure the safety of your items.
Product Specifications:
- Model: NR-215 Weekender
- Manufacturer: Nelson Rigg
- Address: 3518-A Lake Center Dr. Santa Ana, CA 92704
- Contact Information: Tel (714)850-1811, Fax (714)850-1848,
- E-mail: info@nelsonrigg.com
- Website: www.nelsonrigg.com
Product Usage Instructions
- Ensure that the bag is completely covered with the rain cover.
- Wrap the bottom bungee around under the bag to secure it.
- Use the side attachment straps to secure the rain cover.
- Take the strap with the male buckle and pass it around the luggage rack or frame.
- Lift the rain cover flap and insert the male buckle through the slot.
- Reconnect the male buckle into the female buckle located under the cover.
- Fasten the cover flap closed.
- Repeat steps 4-7 on all four straps of the bag.
Warning
Always ride safely and adhere to local highway regulations. It is essential to wear a helmet and protective apparel while using this product.
INSTRUCTIONS
Please read the instructions carefully before installation. We recommend this product be installed by a qualified and experienced motorcycle technician. If you are unsure of any of the below directions and/or your ability to correctly and securely install this product, please contact us or your local dealer for help. The below diagrams show typical installation, your motorcycle may be different so please use diagrams as a guide. Make sure your motorcycle is clean and free from dirt, road grime, etc. where the Nelson-Rigg luggage mounts.
USE
-
With a bag sitting on a luggage rack or passenger seat, loosen the self-fastening straps.
-
With straps passing through the “D” ring, slide over your backrest. Pull to tighten and lay the strap back onto itself, connecting the self-fastening straps. For the side attachments pass the strap with the male buckle around the luggage rack or frame and reconnect
-
with the female buckle attached to the bag. Make sure the male buckle clicks into place. Repeat this on all 4 straps on the bag. Make sure the bag has little if any movement up, down, or left and right before riding. Always recheck mounting before every ride.
-
In case of inclement weather use the included rain cover to protect your bag.
-
After the bag is completely covered and the bottom bungee wraps around under the bag, secure the rain cover using the side attachment straps.
-
Pass the strap with the male buckle around the luggage rack or frame, lift the rain cover ˜ap insert the buckle through the slot, and reconnect into the female buckle under the cover. Fasten the cover and close it. Repeat on all 4 straps on the bag.
Warning
Read the installation instructions and make yourself familiar with the process
of installing the Nelson-Rigg® product (s) on your bike. It is your
responsibility to mount the product correctly as outlined in these
instructions. Nelson-Rigg® products are intended for use at USA street legal
speeds as posted by the individual States. Nelson-Rigg® luggage must not be
overloaded. Max carrying capacity is 10 lbs per bag or the maximum load
suggested by the manufacturer of the vehicle, whichever is less. Failure to
adhere to these warnings may result, but is not limited to: the luggage
becoming detached, the product becoming tangled in moving parts of the
vehicle, unstable vehicle dynamics, and a reduction in the ability to control
the vehicle. The result(s) could lead to serious injury.
Always ride safely, adhering to the local highway regulations. Always wear a
helmet and protective apparel.
CONTACT
- 3518-A Lake Center Dr. Santa Ana, CA 92704
- Tel (714)850-1811 Fax (714)850-1848
- E-mail: info@nelsonrigg.com. www.nelsonrigg.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>