Teddy Pardo DMP-A6 Eversolo Conversion Kit User Guide
- June 13, 2024
- Teddy Pardo
Table of Contents
Teddy Pardo DMP-A6 Eversolo Conversion Kit User Guide
What’s included
- TeddyPardo dedicated power supply.
- Panel adapter wired with DC plug
- DC cable
- Torx key
Step 1: Place the device upside down, remove 7 screws holding the bottom chassis, using the torx key.
- Make sure to keep the screws in an empty cup.
- Do not remove the SSD holding screw.
Step 2: place the device on its side, power entry socket facing upwards. Keep
it on its side throughout the conversion process.
Remove 6 screws holding the back panel.
Step 3: Holding the top cover firmly, pull the bottom half slightly backwards
and to the side.
- Do not use force.
- Keep the front side of the device as stationary as possible.
- Opening the device forcefully may break the front panel ribbon wires!
Result of step 3. note the fragile ribbon wires at the right side of the
picture.
Make sure those wires are not overstretched, and in any case, do not touch
those wires.
Step 4: hold the power supply connector to unlatch it, then disconnect the
supply cable from the main board.
- Do not apply force.
- No need to disconnect the cable from the power supply board.
Result of step 5.
Step 7: Prepare the panel adapter and its two bracings.
Start by inserting the wire harness through the power entry opening.
· Keep the device steady on its side.
Result of step 7
Result of step 9
Step 10: Close the top cover, reverse step 3, then step 2, then step 1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>