BOSCH SMV4HMX01Z Dishwasher User Guide

June 13, 2024
Bosch

BOSCH-LOGO

BOSCH SMV4HMX01Z Dishwasher

BOSCH-SMV4HMX01Z-Dishwasher-PRODUCT

Product Information

The product is a dishwasher that allows users to conveniently clean their tableware. It is equipped with various features and settings to ensure optimal performance.

Setting up Home Connect

To make the most of the appliance, users can connect it to a mobile device using the Home Connect app. This enables them to control and change settings easily.

  1. Install the Home Connect app on your mobile device and follow the instructions.
  2. Scan the QR code with the Home Connect app.

Overview of Water Hardness Settings
The dishwasher offers different water hardness settings to suit individual preferences. The following table provides an overview of the available settings:

Hardness Range Setting Value
Soft (0 – 1.1 mmol/l) H00
Soft (1.2 – 1.4 mmol/l) H01
Medium (1.5 – 1.8 mmol/l) H02
Medium (1.9 – 2.1 mmol/l) H03
Medium Hard (2.2 – 2.9 mmol/l) H04
Hard (3.0 – 3.7 mmol/l) H05
Hard (3.8 – 5.4 mmol/l) H06
Hard (5.5 – 8.9 mmol/l) H07

Refer to the instruction manual for a table of country-specific units.

Adding Special Salt
To ensure the proper functioning of the appliance, special salt should be added to the designated dispenser before starting a program.

  1. Unscrew the lid of the special salt dispenser and remove it.
  2. If it’s the initial start-up, fill the dispenser with water.
  3. Add the special salt to the dispenser, ensuring that no detergent is added.
  4. Place the lid back on the dispenser and turn it to close.

Adding Rinse Aid
Rinse aid can be added to enhance the drying performance and prevent water spots on the tableware.

  1. Press the catch on the lid of the rinse aid dispenser and lift it.
  2. Add rinse aid up to the maximum mark.
  3. Close the lid of the rinse aid dispenser until it clicks into position.

Product Usage Instructions

  1. Load the tableware into the dishwasher, ensuring that it is suitable for dishwasher use and removing large remnants of food.
  2. Add detergent to the dry detergent dispenser according to the recommended amount.
  3. Switch on the appliance.
  4. Select the desired programme based on the specific cleaning needs.
  5. Start the programme.
  6. At the end of the programme, remove the tableware from the dishwasher.
  7. To cancel a programme, press and hold the cancel button for approximately 4 seconds. The programme will be cancelled and end after about 1 minute.

Cleaning Filters

  1. After each wash, check the filters for any residue.
  2. Turn the coarse filter anticlockwise and remove the filter system for cleaning.

Before using for the first time, read the instruction manual and the safety information it contains.

Setting up Home Connect

Tip: Connect your appliance to a mobile device. You can conveniently change all settings using the Home Connect app.

  1. Install the Home Connect app on your mobile device and follow the instructions.
  2. Scan the QR code with the Home Connect app.

Overview of water hardness settings

You can find an overview of the water hardness values that can be selected here.
A table of country-specific units can be found in the instruction manual.

Setting the water softening system

  1. Press .
  2. To open the basic settings, press Setup 3 sec. for 3 seconds.
    • The display shows xx.
    • The display shows set.
  3. Press Start repeatedly until the right water hardness has been set.
  4. To save the settings, press Setup 3 sec. for 3 seconds.

Programmes

The programme data has been measured in the laboratory according to European standard EN 60436.
The consumption figures depend on the programme and additional function selected.
The runtime will change if the rinse aid system is switched off or rinse aid needs to be added.

BOSCH-SMV4HMX01Z-Dishwasher-5

INSTRUCTION

BOSCH-SMV4HMX01Z-Dishwasher-6

Adding special salt

To avoid damage to the appliance, only add special salt to the dispenser for special salt just before the programme starts.

  1. Unscrew the lid of the dispenser for special salt and remove.
  2. On initial start-up: Fill the dispenser right up with water.
  3. Add the special salt to the dispenser. The water in the dispenser is displaced and forced out. Never add detergent.
  4. Place the lid back on the dispenser and turn to close.

Adding rinse aid

  1. Press the catch on the lid of the dispenser for rinse aid 1 and lift 2.
  2. Add rinse aid up to the max mark.
  3. Close the lid of the dispenser for rinse aid.
    • The lid clicks into position.

Adding detergent

  1. Add the detergent to the dry detergent dispenser.
  2. Close the lid of the detergent dispenser.
    • The lid clicks into position.

How to use your appliance

  1. Load the tableware.
    Only clean tableware that is suitable for dishwashers. Remove large remnants of food from the tableware. Check that the spray arms can rotate freely.

  2. Add detergent.

  3. Switch on the appliance .

  4. Select the programme.

  5. Start the programme Start.

  6. Remove the tableware at the end of the programme.

  7. To cancel the programme, press Reset 4 sec. fo approx. 4 seconds.
    The programme is cancelled and ends after approx. 1 minute.

Cleaning filters

  1. After each wash check the filters for residue.
  2. Turn the coarse filter anticlock- wise 1 and remove the filter system 2.
  3. Pull down the microfilter to remove.
  4. Press the locking catches 1 together and lift the coarse filter out 2.
  5. Clean the filter elements under running water.
  6. Re-assemble the filter system.
  7. Insert the filter system into the appliance and turn the coarse filter clockwise.
    Make sure that the arrow markings match up.

Cleaning spray arms

  1. Unscrew the upper spray arm 1 and pull down to remove 2.

  2. Pull up the lower spray arm to remove.

  3. Check the outlet nozzles on the spray arms for blockages under running water and remove any foreign bodies.

    • Insert the lower spray arm.
      The spray arm clicks into position.
  4. Insert the upper spray arm and screw it firmly in place.

Clean wastewater pump

  1. Disconnect the appliance from the power supply.
  2. Remove the filter system.
  3. Scoop out any water.
  4. Prise off the pump cover using a spoon and grip it by the crosspiece.
  5. Lift the pump cover inwards at an angle and remove.
  6. Remove any remnants of food and foreign bodies in the area of the impeller.
  7. Insert the pump cover 1 and press down 2.
    • The pump cover clicks into position.
  8. Install the filter system.

Troubleshooting

BOSCH-SMV4HMX01Z-Dishwasher-20

BOSCH-SMV4HMX01Z-Dishwasher-21

BOSCH-SMV4HMX01Z-Dishwasher-22

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals