SONNEMAN 2099 Labyrinth 101 Inch Mini Chandelier Instruction Manual
- June 13, 2024
- SONNEMAN
Table of Contents
SONNEMAN 2099 Labyrinth 101 Inch Mini Chandelier
Product Information and Warnings
IMPORTANT
- Always disconnect the power before installing or replacing Luminaires and before cleaning or other maintenance.
- Consult a qualified, licensed electrician to ensure correct branch circuit conductor.
- Please read all included assembly instructions and warnings carefully before installation. Contact Customer Service if you have any questions or concerns.
- Before installation, please confirm that the fixture is compatible with your supply voltage and dimming system, if present.
- LEDs are highly sensitive electronic devices, and must be treated with care. Do not open any factory sealed compartments, and avoid touching the LEDs with your hands or any object.
- Although all our fixtures are equipped with protective devices, LED electronic systems are vulnerable to power surges and supply variations. Do not install LED fixtures on the same circuit as any motors, appliances, or HVAC systems.
- Remote LED Driver installation must be done by a licensed electrician and in accordance with local building and electrical codes. Remote installations should be in an accessible location, as close to the fixture as possible. The appropriate wire gauge must be used to limit the voltage drop to avoid overloading the LED Driver.
- Any mounting hardware is provided for your convenience and should be used with discretion. Always use the appropriate hardware for the mounting surface.
What’s in the box
| Luminaires and Arms | Connectors Canopy and Tools |
|---|
- 4 Powered Arm (10)
- 12 Powered Arm (2)
- 4 Unpowered Arm with Cap (9)
- 12 Unpowered Arm with Cap (3)
- 20 Unpowered Arm with Cap (1)
- 12 Unpowered Arm (3)
- 20 Unpowered Arm (1)
- 28 Unpowered Arm (1)
- 12 Luminaire (2)
- 20 Luminaire (2)
- 28 Luminaire (2)
- 36 Luminaire (1)
- 12 Luminaire with Cap (5)
- 20 Luminaire with Cap (5)
|
- Connector (10)
- Powered Connector (2)
- Hanging Connector (4)
- Canopy (1)
- Slotted Screwdriver (1)
- Insulating Sticker (3)
- Cable with Cap (5)
- Power Cord with Cap (2)
Preparing and installing cable grippers
- Use Fig.1 (top view of the assembly) to map the locations and install the Canopy (P1 / P2), and provided Anchors (A-F).
- Note the perimeter of the fully assembled fixture relative to the center of the canopy.
A C A
27
4 12
4 12
12
B D A
58
12 12 4
4
A P2 Canopy
P1
19
3 16
20
35
3 16
36
4
13 16
12
20
20
13 16
F
E 43
- Note the volume of the assembled fixture, the top of Subassembly P1 will be the top of the fixture. Use this to adjust the assembly height. See Fig. 1-B to confirm the suspension point locations in the final assembly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>