DoubleTake CAT-27 Sentry Locking Dash Instruction Manual
- June 13, 2024
- DoubleTake
Table of Contents
DoubleTake CAT-27 Sentry Locking Dash
NOTE: Holes for electronic components should be cut out prior to mounting the dashboard. These cut out locations are at user’s discretion.
IMPORTANT: Read through all instructions before beginning installation.
CAR PREPARATION
STEP 1.1 REMOVE UPPER TRIM
Remove the upper body dash area trim by unscrewing the Torx pan head screws at the 4 locations in the trim.
STEP 1.2 REMOVE KEY SWITCH COVER PLATE
Remove the factory key switch cover plate and detach all electrical components.
STEP 1.3 REMOVE ELETRICAL COMPONENTS
Remove all electrical components from the factory dash. Set aside to be installed in Sentry Dash.
STEP 1.4 ADD WIRING EXTENSIONS
Add 12” wire extensions to the wires of electrical components that need to be transferred to the face of the new dash.
STEP 1.5 REMOVE STEERING WHEEL
Remove the center cap/scorecard holder from center of steering wheel. Remove lagre nut and pull steering wheel off of steering column shaft
CLUB CAR PRECEDENT, ONWARD, & TEMPO / DOUBLETAKE PHOENIX-PD & PHANTOM
Car with factory components removed and ready for Sentry Dash installation
SENTRY DASH INSTALLATION
STEP 2.1 POSITION SENTRY DASH
Sentry Dash fits over existing factory cup holders. Slide the Sentry Dash over the steering column (A), while pulling any wiring for electrical components through the lower outer openings (B).
STEP 2.1 ATTACH DASH WITH SCREWS
Once the dash is fully seated over front cowl, use either the same 4 Torx pan head screws removed in step one, or the new ones provided, to attach the Sentry Dash across the top of dash frame (C). (Mounting holes located at the bottom of the dashboard (D) are optional).
TRIM KIT INSTALLATION
STEP 3.1 ATTACH CUP HOLDER INSERTS
Remove protective film from outer surface of Cup Holder inserts (E). Attach
inserts to Sentry Dash with peel and stick tape provided.
NOTE: Items are left and right handed. Check for correct positioning
before attaching with double-sided tape. The adhesive is automotive quality
and may not be removeable without damage to the insert once applied.
STEP 3.2 ATTACH STORAGE AND NOSE INSERTS
Remove protective film from outer surface of Storage insert (G) and Nose insert (H). Then attach inserts to Sentry Dash with peel and stick tape provided.
STEP 3.3 PREPARE FACEPLATE
Cut the necessary holes in the Faceplate insert (I) to install the electrical components that were taken out in Step one. (Placement of these components varies by user). Install components and reconnect wiring.
STEP 3.4 INSTALL FACEPLATE
Insert the Faceplate insert into the lower dash opening and attach with the 4 small flat head screws provided.
STEP 3.4 REATTACH STEERING WHEEL
Reattach the steering wheel to the steering column.
Installation is Complete.
Customer Support
(This page left blank intentionally)
Sentry Dash – Club Car Precedent – Blank
CAT-27: Sentry Dash – Club Car Precedent / July 29, 2022 / Manufactured By Custom Golf Car Supply, Inc. www.DoubleTakeGolfCar.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>