BROMIC Platinum and Tungsten Smart Heat Gas Accessories Instruction Manual
- June 13, 2024
- Bromic
Table of Contents
BROMIC Platinum and Tungsten Smart Heat Gas Accessories
Product Information
The product being referred to in the user manual is a Heat Deflector, manufactured by Platinum Heating. It is designed to be installed with a heater, mounted on a ceiling pole. The heat deflector helps to redirect the heat produced by the heater, preventing damage and increasing efficiency.
Installation Instructions
Heat-Deflector Installation
- Fix the heater to the lower paddles using suitable fixtures.
- Note: Platinum Heating recommends running power and gas lines to the heater inside the pole to reduce visibility and likelihood of damage.
Ceiling Pole Installation
WARNING: When mounting the ceiling pole, ensure that the anchoring to the structure is of sufficient strength, quality, and workmanship to support the weight of the heater and any other load that could be applied to the fixture. The ceiling pole must be perpendicular (90 degrees) to the ground when mounted, regardless of a pitched or flat ceiling.
- Mount the top bracket to the ceiling or support beam using suitable fixings with a minimum length of 60mm.
- Assemble the pole to the mounting bracket using M8x100mm and M19x100mm bolts. Fix them using nuts and washers provided.
- Assemble both lower paddles to the pole (back to back) and insert 3 M10x100mm bolts. Fix them using nuts and washers provided.
For more information and resources, visit bromic.com/heat.
INSTALLATION INSTRUCTIONS – HEAT DEFLECTOR
HEAT-DEFLECTOR INSTALLATION
-
Assemble Heat Deflector following instructions supplied in the Heat Deflector carton.
-
Mount Heat Deflector to back of heater by loosening the two screws and secure brackets underneath washers.
-
Re-tighten screws to original position using screw driver.
-
Fix Heater to Lower paddles using suitable fixtures.
NOTE: Platinum Heating recommends running power and gas lines, to the heater, inside the pole to reduce visibility and likelihood of damage.
CEILING POLE INSTALLATION
WARNING
When mounting ceiling pole, ensure the anchoring to the structure is of
sufficient strength, quality and workmanship to support the weight of the
heater and any other load that could be applied to the fixture.
Note: Ceiling pole must be perpendicular (90deg) to the ground when
mounted (irrespective of pitched or flat ceiling).
- Mount Top Bracket to ceiling or support beam using suitable fixings no less than 60mm length.
- Assemble pole to the mounting bracket using the M8x100mm and M19x100mm bolts, and fix using nuts and washers (as supplied).
- Assemble both lower paddles to the pole (back to back) and insert 3 M10x100mm bolts and fix using nuts and washers (as supplied).
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>