BOUNDMOTOR M1 Direct Drive Electric Skateboard User Guide

: June 13, 2024
: Boundmotor

Table of Contents

WARNING
PROTECTION
OVERVIEW
SPECIFICATION
CHARGE THE REMOTE/ BOARD
CHECK THE REMOTE/ BOARD BATTERY LIFE
OPERATE THE BOARD WITH THE REMOTE
PAIRING
VESC
BATTERY SAFETY
WARRENTY
CONTACT US
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BOUNDMOTOR M1 Direct Drive Electric Skateboard

WARNING

RISK OF DEATH OR SERIOUS INJURY

Whenever you ride a board, you risk death or serious injury from loss of control, collision, and falls. To ride safely, you must read and follow the instructions and warnings in the manual.
Always wear a helmat when riding. Avoid water, wet surfaces, slippery/ uneven surfaces, steep hills, traffic, cracks, tracks, gravel, rocks, or any obstacles that could cause a loss of traction and cause a fall. A void night riding, areas with poor visibility, and small spaces.
Warning: Do not ride on side-hills or on an incline of more than 10 degrees.
Do not ride at speed which you would not safely control the board. In case of wireless interface or battery error, you may need to rely on skating techniques like foot braking or sliding to stop.

WARNING: AVOID WATER!
Your board is not completely waterproof, you can easily go through the puddles
but don’t soak the board in the water. Water damage is not covered under the warrant

WARNING : PINCH POINTS!

Keep Fingers, hair and clothing away from belts , motors , and all moving parts.

WARNING : RISK OF ELECTRONIC SHOCK!

Do not open or tamper with electronics housing. which also voids the warranty.

PROTECTION

ALWAYS WEAR A HELMET
Find an open, flat area with clean pavement for your first ride.
Read the warning on the skateboard and at the beginning of this manual.

OTHER RECOMMENDED PROTECTION EQUIPMENT

wrist guards
elbow pads
knee pads.

Move the Throttle Wheel in small increments.
Keep a wide stance on the board.
Keep a low center of gravity.
Lean forward when accelerating.
lean backward when braking.

OVERVIEW

SPECIFICATION

PERFORMANCE
Max. User Weight: 120kg / 265 lbs
Max. Range: 25-30 krn(l2s2p) 40-45km(l2s3p) Riders weight: 75KG.
Speed Mode: 30krn/h 40km/h 50krn/h
BOARD
Deck Material: Canadian Maple / Carbon Firber
Wheel Material: Rubber
Battery Type : Li-ion
Battery Cell Quantity: 24/36pcs
CHARGER
Input: AC 100-240V Max. Output:50.4V / 4A
CONTROLLER
Material: ABS Plastic
Battery Type: Lithium
Wireless Connection : 2.4 GHz

CHARGE THE REMOTE/ BOARD

There is a switch on the back of the charger, 11 0v or 220v, Make sure to switch to the corresponding voltage mode. Otherwise, the board can not be full charged.

LED 1 AC POWER ON
LED 2 CHARGER CONNECTED
LED 2 CHARGING
LED 2 FULLY CHARGED

CHECK THE REMOTE/ BOARD BATTERY LIFE

OPERATE THE BOARD WITH THE REMOTE

Push the throttle forward to accelerate.
Move the Throttle Wheel in small increments.
Keep a wide stance on the board. Keep a low center of gravity. Lean forward when accelerating.

Pull the throttle backward to brake.
Move the Throttle Wheel in small increments.
Keep a wide stance on the board.
Keep a low center of gravity.
Lean backward when braking.

PAIRING

Hold the power button with the GEAR button until the 4 red lights blinks.
Then, turn on the Vesc with the power button (Vesc) and they should pair up automatica

VESC

If you are not familiar with VESC, please do not change any settings. defects or malfunction caused by misuse, abuse or improper maintenance are not coverd under the warrantty.

NOTE:

Please do NOT upgrade the firmware, if you have upgraded the firmware to v4.2, some functionality will be lost, such as speed mode switching and front-back direction switching.
Use VESC tool Vl.29 to customize your settings, link: https://bit.ly/vesctool
BOUNDMOTOR.COM

BATTERY SAFETY

The lithium-ion battery can explode or cause a fire if they are used incorrectly.
Therefore, it is recommended to read the following instructions very carefully:
-Before riding the board, check the battery pack carefully, especially the protective seal.
Make sure it is undamaged and intact. If in doubt, take the battery to a chemical waste disposal facility.

Never drop the board.
Store the board with battery inside in a dry place.
Never expose the battery to a temperature above 100-celsius degrees.
Only use an official board charger for charging board battery.
Never leave the board unattended when charging.
Never make the board work when charging.
If you are not planning to use the board for about 6 months or longer, charge fully and charge it once a month. A lithium-ion battery that has been left empty for too long, the battery will no longer be rechargeable.
Charge the battery for 6 hours before first-time use. This gives it a better long-term performance.

WARRENTY

LIMITED WARRANTY:
This board is covered under 180 – day warranty that covers defects in workmanship and material.
This does not cover damages caused by abuse, misuse, negligence, accident, or riding in water.
If the product has a manufacturing defect within180days since the shipping date,
please contact the dealer before shipping the board back:? in order to get a return authorization.
FOR ALL RETURN AND WARRANTY SHIPPING:
Please keep your shipping box. The warranty does not include damage from shipping in insufficient packaging.