ENDON 103829 Eldon Wall Light Instructions

: June 13, 2024
: ENDON

Table of Contents

Safety Warnings
Care and maintenance
Troubleshooting
PIR Adjustment
Assembly Instructions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Installation and Safety Instructions
Outdoor Wall Light Fitting

Safety Warnings

These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply in accordance with current IEE wiring regulations, and should be installed in accordance with local building regulations.
This product is suitable for use outdoors but should not be immersed in water / sited in areas likely to be heavily splashed, either from above or below, or subjected to standing water.
If being fitted in a bathroom, this product is suitable for bathroom outside zones as specified by the right diagram.
The appliance must be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30mA.
This product is rated IP44( definition e.g. splash proof / rain proof etc).
Ensure that the screws and cable entry points are sealed to maintain the IP rating of the product.

This is a Class l product and must be Earthed. The terminal blocks are supplied according to requirements of the fitting.
IMPORTANT: Always switch off the mains supply during installation or maintenance. We recommend that the fuse is withdrawn or the circuit breaker switched off at the distribution board whilst work is in progress (turning off the light switch is not sufficient). Connection should be via a wall switch to enable safe isolation. The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for “masonry” only. Other fixings are not supplied and must be purchased.
Decide on the position of the light fitting or remove existing light fitting. Note the position of the electrical connections, and ensure there is a solid mounting surface, Preferably a wooden joist or joist bridge, to support the weight of the light fitting.
Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation. Never put anything on the product or hang anything on any part of this product.
IMPORTANT: Ensure that all electrical connections are tight and that no loose strands are left out of the terminal.
Never fit bulbs of a higher wattage than those specified on the label (as these may cause over heating and damage the fitting).
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or local store for recycling advice.

Care and maintenance

For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Troubleshooting

When the bulb does not light after installation:

Ensure there is no electricity failure.
Ensure all the connections are secure.

If you have any doubt about installation/use of this product, consult a qualified electrician.

PIR Adjustment

This product has an integrated PIR sensor.
To access the adjustment screw, flip the black cover on the PIR sensor to the bottom left or right. Take great care when adjusting the sensor screws not to over tighten as they can be easily broken.

The unit must be installed in a vertical position and fitted 1.8-2.5M above the ground.
The PIR sensor can be adjusted, allowing the detection distance to be altered to suit the location. The detection angle is set at 110º. The duration that the lamp stays on can also be altered from 5 seconds – 5 minutes. The LUX range is 10-2000 lux. Use a small screwdriver to adjust the TIME and SENS screws.
For adjustability in daylight it will be necessary to cover the sensor to simulate night time.

ENDON 103829 Eldon Wall Light - PIR Adjustment