Endon 106265 Ridgeton Light Instructions
- June 13, 2024
- ENDON
Table of Contents
Endon 106265 Ridgeton Ligh
Product Information
The Flush Light Fitting is a ceiling light designed for domestic use. It is suitable for connection to a 220-240V~ 50Hz power supply and should be installed in accordance with local building regulations. This product is not suitable for use in bathrooms. Important safety warnings include not placing anything on or hanging anything from the product. It is crucial to ensure that all electrical connections are tight and secure, with no loose strands left out of the terminal. Bulbs should not exceed the specified wattage mentioned on the label to prevent overheating and damage to the fitting. Waste electrical products should be recycled where facilities exist.
Installation and Safety Instructions Flush Light Fitting
Safety Warnings
These instructions are for your safety. Please read through them thoroughly
before use and retain them for future reference. If you are in any doubt about
installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply in
accordance with current IEE wiring regulations, and should be installed in
accordance with local building regulations. It is for domestic ceiling use
only, and is not suitable for a bathroom location.
This fitting is a Class I I, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth.
IMPORTANT
lays switch off the mains supply during installation or maintenance. We
recommend that the fuse is withdrawn or the circuit breaker switched off at
the distribution board whilst work is in progress (turning off the light
switch is not sufficient). Connection should be via a wall switch to enable
safe isolation.
The product must be securely fixed to the mounting surface using the screws
and wall plugs supplied. The screws and wall plugs supplied are suitable for
“masonry” only. Other fixings are not supplied and must be purchased.
Decide on the position of the light fitting or remove existing light fitting.
Note the position of the electrical connections, and ensure there is a solid
mounting surface, Preferably a wooden joist or joist bridge, to support the
weight of the light fitting.
Take care not to drill into any pipes or mains cables beneath the surface
during mounting holes preparation.
Never put anything on the product or hang anything on any part of this
product.
IMPORTANT
Ensure that all electrical connections are tight and that no loose strands are
left out of the terminal.
Never fit bulbs of a higher wattage than those specified on the label (as
these may cause over heating and damage the fitting).
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
local store for recycling advice.
Care and maintenance
For bulb replacement, switch off the product (preferably, isolate it at the
distribution board) and allow it to cool down (Caution: bulb gets hot during
use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this
product.
Troubleshooting
When the bulb does not light after installation:
- Ensure there is no electricity failure.
- Ensure all the connections are secure.
If you have any doubt about installation/use of this product, consult a qualified electrician.
Assembly Instructions
If glass cannot easily be installed, please adjust/twist the metal struts so they are inline with the glass when installing.
Scan OR code for multi-language
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>