greemotion GM-2017 Bordeaux FirePit Dining Table Instructions
- June 13, 2024
- greemotion
Table of Contents
greemotion GM-2017 Bordeaux FirePit Dining Table
Product Information
| Product Name | GM-2017 Bordeaux FirePit Dining Table |
|---|---|
| Manufacturer | greemotionUSA |
| Customer Support | 1-909-348-5495 |
| Website | greemotionusa.com |
| support@greemotionusa.com |
Product Usage Instructions
- Before using the product, read the washing instructions on the sewn-in care label on the covers.
- Assembly Instructions
- Place the Table Top (B) face-down and align the Base (A).
- Secure the washer (G) and bolt (F) using the supplied Allen key (H).
- Rotate the table upright and insert the Ice Bucket (E).
- If desired, add the Burner Grate (D) and use Covers (C) on the Ice Bucket (E) and burner when not in use to avoid dirt and dust build-up.
- To add a propane tank, slide open the side door and place the tank onto the bottom frame. Secure it in place by rotating the screw clockwise. Attach the table’s burning system to the tank by rotating clockwise to its connector.
- Switch Usage Instructions
- Lighting
- Open the igniter button and install an AAA battery (not included), then secure the cap back on.
- Before use, make sure that the control knob is in the OFF position.
- Turn the propane cylinder gas valve to fully open position.
- Press down on the control knob and turn counter clockwise to the LOW position.
- Push in the gas control knob all the way and hold.
- Continue to press the ignition button for 15 seconds.
- Adjusting and Shutting Down
- If the burner is not lit, press down the control knob and turn clockwise to the OFF position.
- Repeat step 1 after 5 minutes.
- When the burner is lit, press down the control knob and turn it to the desired heat output position between LOW and HIGH.
- Press down and turn the control knob clockwise to the OFF position to shut down the appliance.
- Turn off the cylinder gas valve.
- Note: To extinguish the flame, push the control knob in and rotate clockwise.
Types of Gas| Min. Gas supply for input| Adj. Maximum Inlet Pressure| Manifold
Pressure| Gas Rating
---|---|---|---|---
PROPANE GAS| 25 psi| 250 psi| 11 in.w.c| 46,000 Btu/hr
Caution: The gas pressure regulator provided with this appliance must be used. This regulator is set for an outlet pressure of 11 inches water column.
SAFETY INSTRUCTIONS AND WARNINGS
- The product is to be used exclusively for its intended purpose.
- Regularly check the condition and functionality of the product. If you notice any damage, the product should no longer be used.
- Only use the product on solid and level ground.
- Make sure the product is positioned securely.
- WARNING! Risk of clamping/crushing fingers during assembly and disassembly of the product.
CLEANING AND MAINTENANCE
The effects of the weather can cause slight alterations to the appearance of
the garden furniture. Please store the garden furniture in a dry place during
winter. To clean the piece of furniture, use a damp cloth and for more
stubborn dirt use a mild soap solution and a soft brush. Never use aggressive
cleaning agents, pressure washers or steam jets to clean the product. To clean
the cushion/seat cover quickly, use a damp soft cloth. Some stains can be
removed with a mild soap solution and a soft brush. Never use abrasive
cleaning agents or solvents. Make sure that the cushion filling does not
become wet and that no moisture damage or mould can build up
on the inside! When it rains or there is moisture in the air, the cushions and
pads should be taken indoors and stored in a protected and dry location.
Cushions/pads that have become wet should be allowed to dry out completely. Do
not fill damp cushions/pads! The covers can be removed, allowing them to be
washed in the washing machine. Remove the cover, turn it inside out and zip
close. Wash the cover with similar colours in the washing machine.
IMPORTANT
Be sure to read the washing instructions on the sewn-in care label on the
covers!
1-909-348-5495
greemotionusa.com
support@greemotionusa.com
/greemotionUSA
PARTS
HARDWARE
ASSEMBLY INSTRUCTIONS
Place Table Top (B) face-down. Align Base (A). Secure washer (G) and bolt (F) with supplied Allen key (H).
If desired, add Burner Grate (D).
To avoid dirt and dust build-up, use Covers (C) on Ice Bucket (E) and burner
when not in use. To add propane tank, slide open side door and place tank onto
the bottom frame. Secure in place by rotating the screw clockwise.
Attach the table’s burning system to the tank by rotating clockwise to its
connector.
To add propane tank, slide open side
door and place tank onto the bottom frame. Secure in place by rotating the
screw clockwise.
Attach the table’s burning system to the tank by rotating clockwise to its
connector.
-
Step 1: Lighting
Open the igniter button and install an AAA battery (not included), then secure the cap back on. Before use, make sure that the control knob is in the “OFF” position. Turn the propane cylinder gas valve to fully open position. Press down on the control knob and turn counter clockwise to the “LOW” position. Push in the gas control knob all the way and hold. Continue to press the ignition button for 15 seconds. -
Step 2: Adjusting and Shutting Down
If the burner is not lit, press down the control knob and turn clockwise to the “OFF” position. Repeat step 1 after 5 minutes. When the burner is lit, press down the control knob and turn it to the desired heat output position between “LOW” and “HIGH”. Press down and turn the control knob clockwise to the “OFF” position to shut down the appliance. Turn off the cylinder gas valve.
Note: To extinguish the flame, push the control knob in and rotate clockwise.
CARE AND MAINTENANCE
- Do not use aerosol polish or any other flammable material to clean the burner while it is in use.
- Inspect and clean the burner regularly. Use a wire-bristle brush to clean the burner surface. A straightened paper clip is useful to remove debris or rust from the small burner ports.
- Wash frame parts with mild soap and water, rinse thoroughly, and dry completely. Do not use bleach, acid, or any other solvents on the frame parts.
- Inspect and tighten all of the bolts and fasteners on a regular basis to ensure the proper performance and safety of your appliance.
- When not in use, we recommend that it be stored in a dry and secure area. Always disconnect the propane gas tank first and store it safely outside.
- The minimum clearance from the sides, rear, and top of unit to adjacent combustible construction: 2′ (61 cm) from the sides, 2′ (61 cm) from the rear, and 5′ (152.5 cm) from the top.
- Improper lighting operations will cause serious injury and explosion.
TYPES OF GAS :PROPANE GAS
- Min.Gas supply for input Adj.25 psi
- Maximum Inlet Pressure 250 psi
- Manifold Pressure 11 in.w.c
- Gas Ratingv 46,000 Btu/hr
Caution
The gas pressure regulator provided with this appliance must be used. This
regulator is set for an outlet pressure of 11 inches water column.