alora Lighting CH347646 Osorio LED Chandelier Instruction Manual
- June 13, 2024
- alora Lighting
Table of Contents
CH347646
Chandelier
Instruction Manual
CH347646 Osorio LED Chandelier
TECHNICAL SUPPORT
1.855.855.8926
technicalsupport@aloralighting.com
WARNINGS AND CAUTIONS
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
-
This Alora LED fixture comes with pre-wired LED module(s)
-
Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with
the module could cause permanent damage -
For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
-
120V input
NOTICE
- The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
- This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
ASSEMBLY INSTRUCTIONS
Step 1
Remove fixture from its original package.
Step 2
Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b).
Step 3
Attach mounting plate (1c) to electrical junction box (1a) using junction box
screws provided (1e) in hardware package.
Step 4
Determine hanging height of fixture by securing rods (2d) to canopy (2a) and
fixture hub (3a) after feeding fixture wires (LED+ and LED-) through rods.
Step 5
Make proper electrical connections between LED and DC driver, LED- Negative,
LED+ Positive, with wire nuts provided (See Illustration 1 and refer to
diagram on driver).
Step 6
Make proper electrical connections (black to hot “L”, white to neutral “N”,
ground to “GND”) with wire nuts (1b) provided in hardware package and place
driver (4a) in canopy (2a).
Step 7
Secure filament (5c) to fixture arm (5b) by threading clockwise. Attach
filament end (5d) to filament (5c) with end cap (5e). Align holes on fixture
arm (5b) and filament end (5d) with holes on shade (6b), secure with screws
(6a).
Step 8
Attach canopy (2a) to mounting plate (1c) with canopy screws (2b).
You are now ready to enjoy your fixture.
P: 1.855.855.8926
CANADA: 19054 28th Avenue Surrey – BC V3Z 6M3
USA: 3035 E. Lone Mountain Rd – Las Vegas, NV, 89081
www.aloralighting.com
20230619