Shenzhen Xinfuyu Electronic Technology H15A Smart Remote Controller User Manual
- June 13, 2024
- Shenzhen Xinfuyu Electronic Technology
Table of Contents
Shenzhen Xinfuyu Electronic Technology
H15A Smart Remote Controller
User Manual
Description
Pairing operation
Press the[ ]+[ ]for 1 second at the same time, the indicator light flashes
quickly, and release the key.
Insert the USB receiver, the remote control is close to the receiver, and the
indicator is off, indicating that the pairing is successful.
CPI adjustment
Mouse pointer movement speed adjustment
CPI is divided into four gears, and the default gear is the second gear). The
greater the gear value, the faster the movement speed of the rats.
- Increase the speed of the empty mouse: press and hold the [ ] +[ ] , the indicator will flash for three times, and then release it. CPI will increase by one gear on the original basis.
- The speed of the empty mouse slows down: press and hold the[ ]+[ ], the indicator light flashes for 3 times, and then release it, and the CPI is reduced by 1 gear on the original basis.
Infrared learning function
- Press and hold the [OK] and [ ] on the remote control at the same time, the indicator light will light up slightly, and it will light up 3 seconds later
- Press the infrared function key (such as power key) to be learned on the remote control, and the indicator light will flash slowly;
- Use the learned remote control transmitter tube to aim at the remote control transmitter tube to be learned at a distance of 1-5CM, start learning, press the corresponding learning button, and the indicator light will flash three times after learning successfully. Repeat 2-3 steps to learn multiple keys in turn
- Press the [ ] key to exit the learning mode and save the learning data
- Press and hold the [ OK ]+[ ] key for 5 seconds, and the LED flashes 3 times to clear the learning code value and restore the factory settings
Matters needing attention:
If the remote control cannot be turned on, you need to learn the power
button of the original remote control separately
Voice function
This flying mouse voice function defaults to Google Voice. The host needs to install Google Voice Assistant before it can be used.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>