STEG GLORIA 60.4 Mirco Class D 4 Channel Amplifier Instruction Manual

June 13, 2024
STEG

STEG GLORIA 60.4 Mirco Class D 4 Channel Amplifier

STEG-GLORIA-60.4-Mirco-Class-D-4-Channel-Amplifier-
product

  • We appreciate your purchase of a high-fidelity sTEALTH amplifier
  • The quality of the installation may effect the performance and reliability of your product

CLASS D TECHNOLOGY

  • LPF ——————–30Hz-300Hz(600Hz-6KHz)
  • HPF——————–15Hz-300Hz(300Hz-6KHz)
  • FREQUENCY RESPONSE ——–20Hz-20KHz
  • S/ N RATIO —————- >90dB
  • MINIM UM LOAD————-STEREO 4 OHM MIN.
  • BRIDGE 4 OHM MIN.
  • INPUT SENSITIVITY———–200mV-6V
  • INPUT IMPEDANCE———–·600OHM
  • PROTECTION SYSTEM———• YES
  • S U PPLY VOLTAGE———– DC9-16V
  • RMS ——————–4CHx60W@4ohm
  • RMS ——————–4CHx90W@2ohm
  • RMS BRIDGE—————2CHx180W@4ohm

POWER CONNECTION LEADS

Notes on the Power supply

  • Connect the 12V power supply lead only after all the other leads have been connected.STEG-GLORIA-60.4-Mirco-Class-D-4-Channel-Amplifier-fig-1
  • Be sure to connect the ground lead of the unit securely to a metal point of the car. A loose connection may cause a malfunction of the amplifier.
  • Be sure to connect the remote control lead of the head unit to the amplifier’s remote terminal. A loose connection may cause a malfunction of the amplifier.
  • When using car audio without a remote output on the amplifier, connect the remote terminal to the accessory power supply.
  • Use the power supply lead with a fuse attached(30A fuse)STEG-GLORIA-60.4-Mirco-Class-D-4-Channel-Amplifier-fig-2
  • Place the fuse in the power supply lead as close as possible to the car battery.STEG-GLORIA-60.4-Mirco-Class-D-4-Channel-Amplifier-fig-3
  • Make sure that the leads to be connected to the 12V and GND terminal of this unit are larger than 10-gauge (AWG #10) power cables.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals