ML Accessories ML500 Round 500mm LED Illuminated Bathroom Mirror Instruction Manual
- June 13, 2024
- ML Accessories
Table of Contents
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by
the end user for future reference and maintenance.
These instructions should be used to aid installation of the following
product: ML500
SAFETY
- This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
- Please isolate mains prior to installation or maintenance
- Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the circuit cable, fuse or circuit breaker
- Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
- This product is for indoor use only
- This product is Class I and must be earthed
- This product is IP44 rated
INSTALLATION
-
Provide power to the required point of installation
-
Remove the mirror from the base by removing the two screws on the sides
-
Using the base as a template, mark the location for, and drill the fixing holes ensuring not to infringe with any gas/water pipes or electrical cables
-
Feed the mains cable through the rubber grommet on the rear of the fitting to retain IP rating
-
Ensuring the PIR sensor is in the required position, secure the baseplate to the surface using the screws, washers, and wall plugs provided (see Fig. 1)
-
Connect the luminaire to the mains supply ensuring the correct polarity is observed: L -Live (brown), E – Earth (green/yellow), N – Neutral (blue)
-
Refasten the mirror to the base ensuring to align the sensor cut-out with the PIR
-
Switch on and check for correct operation
WARNING
This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed.
GENERAL
This product contains a light source of energy efficiency class E to
Regulation (EU) No. 2019/2015.
This product contains a non-replaceable LED light source and a control gear
which can be replaced by a professional.
Clean with a soft dry cloth only, do not use aggressive cleaning products or
solvents which may damage the product. A glass cleaning solution may be used
on the mirror surface.
This product is non-dimmable.
This product should be dismantled for disposal when it reaches the end of its
life. Please see website for dismantling instructions.
This product should be recycled in the correct manner when it reaches the end
of its life.
Check local authorities for where facilities exist.
WARRANTY
This product has a warranty of 1 year from date of purchase. Failure to install this product in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve the right to alter product specification without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>