SCT RTK-8CP Remote Table Kit User Guide
- June 13, 2024
- SCT
Table of Contents
SCT RTK-8CP Remote Table Kit
Product Information
The RTK-8CPTM is an application guide for the Cisco Codec Pro, Room Kit
Pro, and Dual70G2 Codecs. It supports up to 8 CiscoTable-E/Mic60 Microphones.
The module dimensions for the RTK-8CP-TXTM are H: 1.394″ (35mm) x W: 10.118″
(256mm) x D: 4.484″(114mm). The dimensions for the RTK-8CP-RXTM are the same.
The RTK-8CP-RXTM is a receiver module.
The SCTLinkTM Cable is used with the RTK-8CP-TXTM Transmitter Module. The cable specifications are not provided in the text. However, it is mentioned that the integrator should supply a CAT6STP/UTP cable with T568A or T568B wiring standards and a maximum/maximum length of 10m-100m.
The RJ45 Pinout for the SCTLinkTM Cable is indicated as follows:
- T568A: 12345678 (gGoBbO brBR)
- T568B: 12345678 (oO gBbGbrBR)
It is important to note that the SCTLinkTM cable must always be a single, point-to-point CAT cable without any couplers or interconnections.
Product Usage Instructions
- Ensure you have the Cisco Codec Pro, Room Kit Pro, and/or Dual70G2 Codecs installed and set up properly.
- If using the RTK-8CP-TXTM Transmitter Module, connect it to the Cisco Codec or Room Kit Pro using the provided SCTLinkTMCable.
- If using the RTK-8CP-RXTM Receiver Module, connect it to the Cisco Codec or Dual70G2 Codec using the provided SCTLinkTM Cable.
- When connecting the SCTLinkTM Cable, make sure to follow the T568A or T568B wiring standards as indicated in the RJ45 Pinout section
- Ensure that the SCTLinkTM cable is a single, point-to-point CAT cable without any couplers or interconnections.
- If using multiple Cisco Table-E/Mic60 Microphones, connect them to the appropriate ports on the Cisco Codec or Room Kit Pro.
- Refer to the user manual of the specific Cisco product for further instructions on configuring and using the RTK-8CPTM.
Intallation
Module Dimensions
- RTK·SCP·TX”‘: H: 1.394″ (35mm) x w: 10.118″ (256mm) x D: 4.484″ (114mm)
- RTK·SCP·RXT”: H: 1.394″ (35mm) x w: 10.118″ (256mm) x D: 4.484″ (114mm
SCTLink” Cable Spees
Integrator-Supplied CAT6 STP/UTP Cable T568A or T568B (10m-100m min/max)
The SCTLlnk” cable must always be a single. point-to-point CAT cable with no couplers or interconnections.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>