HAVIT HV9723-IP20-96SM-B Side Mounted LED Strip Instruction Manual

: June 13, 2024
: havit

Table of Contents

HV9723-IP20-96SM-B Side Mounted LED Strip
PRODUCT SPECIFICATIONS
PRODUCT MAINTENANCE AND PRECAUTIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LED STRIP INSTALLATION INSTRUCTIONS

HV9723-IP20-96SM-B Side Mounted LED Strip

HAVIT HV9723-IP20-96SM-B Side Mounted LED Strip - Figure
1

PRODUCT SPECIFICATIONS

INPUT VOLTAGE| 12v DC OR 24V DC LED DRIVER
See Product Data Sheet for specific requirements
---|---
WIRING| PARALLEL
MOUNTING| ALUMINIUM PROFILE OR HEAT SINK
MAXIMUM LENGTH| 5,000MM-20000MM
See Product Data Sheet for Maximum Length
REQUIREMENTS| 12v DC OR 24V DC LED DRIVER
See Product Data Sheet for specific requirements
DIMMING| 0-1/10V, DALI, DMX, RF, WIFI
OPERATING TEMP.| UP TO 65° CELCIUS
AMBIENT TEMP.| -20° TO 50° CELCIUS
MAXIMUM RUNNING TIME| 12HRS PER DAY-
See Warranty T&C’s for full Terms & Conditions
CRI| > 80 OR >90
See Product Data Sheet for specific requirements
BEAM ANGLE| 120°
IP RATING| IP20 I IP54 I IP67
WARRANTY| 3 YEARS REPLACEMENT*
See Warranty T&C’s for full Terms & Conditions

PRODUCT MAINTENANCE AND PRECAUTIONS

LED strip installation must be installed by qualified personnel.
LED strip must be tested and photographed on before installation for warranty validation.
For cutting LED strip, it is necessary to use the standard accessories provided by Havit Lighting (e.g. DC wire, end-cap, front-cap, adhesive, etc.), and according to the correct cutting and connecting methods for the installation.
LED strip cannot be installed in areas where water hazards might be formed, such as the surface of pits and ditches. And similar places in which rain and water may be accumulated easily.
LED Strip must be installed on aluminium surface including heat sink or profile, Aluminium sheets can also be used but must be 3mm or greater in thickness to comply with warranty.
Do not strongly pull or twist the LED strips during the installation process. Also avoid squeezing and scratching LED strips with sharp objects.
LED Strip must be operated within the correct ambient and operating temperature ranges specified on the product data sheets and also in table on this document.
For correct connection of the product, each length of LED strip must be connected to the main power source.
Do not bend LED Strip below 60mm in diameter, Bending below this diameter will cause strip to break and will void warranty.
LED Driver should retain 20% of total load to make sure LED Strip has the full potential to work correctly.
Voltage supplied to LED Strip must be with 5% of required voltage LED Strip requires to work correctly.
Must guarantee that each power source (GND) must be connected.
Pay attention to the power cable during the installment process, Installer must not connect LED Strip incorrectly to LED Driver by making sure polarity is correct and output voltage of LED Driver is same as LED Strip, Incorrect installation may cause damage to LED Strip and warranty will be voided.
Electro-static bands must be worn during installation to avoid any electricity being transferred to LED Strip and causing failure.
During the warranty period, only defective products are acceptable to be replaced by Havit Lighting. Havit Lighting is not responsible for other expenses because of replacement, such as transportation fee, installation fee, etc.