iLOQ Crust Grik Plate Mortise Door Lock Installation Guide
- June 13, 2024
- iLOQ
Table of Contents
Crust Grik Plate Mortise Door Lock
5.1 Installation of the iLOQ Mortise Cylinder
-
Loosen the cylinder set screw of the mortise case to clear the cylinder’s mounting hole.
-
Thread the iLOQ cylinder with the security ring into the mortise lock.
The
security ring could be replaced by a high guard escutcheon to provide an extra
protection to the cylinder and the knob. -
Tighten the cylinder set screw of the mortise lock case.
Insert the ILOQ knob cap into the front of the knob. Press firmly on the cap
until it snaps in.
Operating instructions
6.1 Opening
-
Hold a valid key against the reader knob and wait until the key shows a green light.
Due to the large variety of Android phone models and operating system versions, iLOQ cannot guarantee that all NFCenabled Android phones will work seamlessly with our locks.
Before using the locks, check where the NFC antenna is located in your phone so that you know the best position to hold the phone against the knob. -
Turn the reader knob to unlock the door, then open the door.
After 5 to 15 seconds, the cylinder will automatically be locked. When the cylinder is locked, the reader knob cannot be rotated.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>