BESTEK MRZ3013HU 300W Pure Sine Wave Power Inverter Instruction Manual

June 13, 2024
BESTEK

BESTEK MRZ3013HU 300W Pure Sine Wave Power Inverter

Description

Thank you for purchasing our products. Please strictly comply with the operation guides and notes explained in this manual. Please keep this manual properly and read all the operation quides before operate the machine.

Introduction

Dimension

BESTEK-MRZ3013HU-300W-Pure-Sine-Wave-Power-Inverter-
fig-2

Performance Specifications

  • This product turn DC11V-DC15V input into AC230V # 10V, 50HZ ‡ 3HZ pure sine wave output.
  • This product convert DC12V input into 5V, 4.2A to the USB output (USB with universal recognition).
  • This product was provided with overload protection and automatic recovery reboot.
  • This product was provided with a low-voltage input and over-voltage input protection . When operated at rated load, the low-voltage protection circuit will start when the input voltage is lower than 10.5V ‡ 0.5V, and the red LED light, only when the input voltage returns to 12V ‡ 0.5V, the circuit will returns to normal operation; the over-voltage protection circuit will start when the inputvoltage is higher than 15.5V + 0.5V, and the red LED light, only when the input voltage returns to 15V ‡ 0.5V, the circuit resumes normal operation.
  • Overload Protection:
    1. When the DC input at 12V and the inverter output is greater than 350W- 380W, overload protection will be trigered.
    2. When the USB output current is greater than 4.8A,overcurrent protection willhe trigered

Technical Specifications

Input Voltage DC11-15V
Output AC220-240V/50Hz
USB Output 5VDC /4.2A
Output Rating AC+USB=300W

Protection

| overload protection, short circuit protection, low-voltage protection, over- voltage protection,

over temperature protection

Overload Protection| 350W-380W
Insulating Strength| 3000Vac/5mA/1 min (input – USB Port)
Transfer Efficiency| 2:86%(output power/input power)100%
Operating Temperature| -10 4o·c
Humidity| 10 85%
Dimension| 161.0mm
98.5mm*57.5mm
Weight| 620±209
LED Indicator| Constant Green–power on and in operation;

Constant Red – Inverter shutdown

Operation Guide

  • This product is equipped with independent input power cord .
  • Plug in the inverter into the vehicle’s cigarette lighter socket.
  • The green LED constantly light up means the inverter is ready for use.
  • Connect the DC line, switch the power ON, the green LED constantly light up means the inverter is ready for use.
  • Inserted the charging device into the USB port, AC load into an AC outlet.
  • Notes
  • When installing the inverter, Please enquire professional operators or connect with the dealer.
  • Do not block the vents.
  • Please turn off all the load when the red LED constantly light up; Reduce AC load when the red LED light flashes.
  • Only access the USB and AC load after the green LED light.
  • Don’t douse any liquid into the inverter or use wet cloth to wipe the cabinet. Never touch the AC output or input connector with wet hands.
  • Please don’t use the inverter in sloppy, dusty, high temperature or temperature varies too sharply environment. Suggested environment temperature is -10~ 40 C. Please don’t jam the louver on side of the machine or use the machine beside heat sources such as electric heater and radiator. Please avoid sunshine. dust and the dewing situation.
  • Don’t let self-determination deficient people (such as a child) use the product.

Troubleshooting

  • Problem: AC product will not operate
Possible Cause Suggested Remedy
Loose cable connections Check cable and connections. Tightens required
  • Problem: Inverter will run some small loads, but not large ones.
Possible Cause Suggested Remedy
Voltage drop across DC cables. Shorten cables or use heavier cables
  • Problem: Alarm is sounding
Possible Cause Suggested Remedy

Low voltage shut down or thermal

shutdown has occurred.

| Shorten cables or use heavier cables. Recharge battery. Allow unit to cool. Improve air circulation around unit. Reduce load if continuous operation

is required.

Warranty

Our company provides customers I with 18-Month warranty from the date of purchase.

Contact Us
For any inquires or comments concerning our products, please send an email to cs@bestekcorp.com and we will respond to you as soon as possible.If there is any quality-related issue with the product you may request a REPLACEMENT OR REFUND by submitting a request at our Amazon store.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals